User manual PHILIPS AZ6813

[. . . ] This set complies with the radio interference requirements of the European Community. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. With this player you can use either: · Notes: ­ Old and new or different types of batteries should not be used in combination. ­ Remove batteries if they are empty or if the player is not going to be used for a long time. [. . . ] ­ During SHUFFLE, SHUFFLE REPEAT ALL, REPEAT or while playing a program, searching is only possible within the particular track. You can select up to 99 tracks and store them in memory in a desired sequence. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. y The display shows all stored tracks in sequence. Notes: ­ If you press PROGRAM and there is no track selected, SELECt is displayed. ­ If you try to store more than 99 tracks, FULL is displayed. Y CLEAr is displayed once, PROGRAM goes off and the program is cleared. Note: The program will also be cleared if you ­ interrupt the power supply or ­ open the CD lid, ­ or if the set switches off automatically. When restarting, playback continues from where you have stopped. 1 If necessary press 9 once or twice until the set is switched off. 2 Firmly connect the remote control to LINE OUT/p and the headphones to the remote control's socket. 3 Turn the volume down with VOL F on the remote control and set VOL E on the CD player to position 8. You can connect your CD player to digital equipment (e. 1 Use the mains adapter, switch ESP off and turn down the volume of the appliance that should be connected. 2 Connect an optical cable or signal lead to the OPT OUT socket of your CD player and to the DIGITAL OPTICAL IN/AUX socket of the other appliance. ⷠTo adjust volume and sound, use the controls of the connected appliance. notes: ­ For analogue connections use the LINE OUT/p socket. ­ Playback via OPT OUT does not work if the player is supplied by batteries. 1 Put the CD player on a horizontal , vibration-free and stable surface. Make sure it is in a safe place, where the player is neither a danger nor obstacle to the driver and passengers. [. . . ] We have done our utmost to make the packaging easily separable into two mono materials: cardboard (box) and polyethylene (bags, protective foam sheet). ⷠYour set consists of materials which can be recycled if disassembled by a specialized company. The benefits given to the purchaser by this warranty are in addition to all other rights and remedies which the purchaser has in respect of the product under the Trade Practices Act or other Commonwealth or State Law. Philips Consumer Electronics warrants its products to the purchaser as follows and subject to the stated conditions. [. . . ]