User manual PHILIPS AZ7465

[. . . ] Este aparato no puede provocar interferencia dañina, y 2. Este aparato debe aceptar cualquier interferencia recibida, incluyendo las interferencias que pueden provocar un funcionamiento insuficiente. L'appareil répond aux normes FCC, Part 15 et 21 CFR 1040. 10. Fonctionnement soumis aux deux conditions suivantes : 1. Cet appareil ne doit pas provoquer d'interférences nuisibles, et 2. [. . . ] ­ Remove batteries if they are empty or if the player is not going to be used for a long time. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you. GENERAL INFORMATION / CD PLAY In-car use (connections supplied or optionally available) Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4. 5 V DC, positive pole to the center pin) and the AY 3501 cassette car adapter. 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter jack (only for 12 V car battery, negative grounding), then connect the wired end with 4. 5V DC input jack on the set. If necessary, clean the cigarette lighter jack to obtain a good electrical contact. Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set. Carefully insert the cassette adapter into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Decrease the volume on the set if necessary. Note: If there is no activity, the set will automatically switch off after a while to save energy. Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. yPlayback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. yPlayback starts with the selected track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. ySearching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. FEATURES Programming track numbers You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. yprogram lights up; the track number programmed and P with the total number of stored tracks are displayed. [. . . ] · Press FM or 9 to switch the radio off. FEATURES / TROUBLESHOOTING Antennas The headphone wire is used as an FM antenna. If necessary, move it for optimum reception. Storing radio stations You can store up to 30 radio stations (1-30). 1 Tune to a desired radio station and press PROG. 2 Press PRESET3 , 4 repeatedly if necessary to select the number that should be assigned to this radio station. [. . . ]