User manual PHILIPS AZ8012

[. . . ] Remove the batteries if the set is not to be used for a long time. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. When inserting new batteries, do not try to mix old batteries with the new ones. ⷠRemove the batteries if the set is not to be used for a long time. [. . . ] Direct the aerial by turning the whole set. Press POWER again to switch off the set. Elapsed playback time of current track and current track number elapsed playback time freezes and flashes when CD programme active; also appears briefly when you store a track Programme activated but no tracks selected programme cancelled/ PROG pressed for more than 2 seconds No disc/error in CD operation or with the CD (see Troubleshooting) programme memory full Press POWER again to switch off the set. Selecting a different track During playback, you can use SEARCH ¡ , TM to select a particular track. ­ If you have selected a track number in the stop or pause position, press PLAY/PAUSE 2; to start playback. ⷠPress SEARCH TM once briefly for the next track, or press repeatedly until the desired track number appears in the display. ⷠPress SEARCH ¡ once briefly to return to the beginning of a current track. ⷠPress SEARCH ¡ more than once briefly for a previous track. The CD is played at high speed and low volume. When you recognize the passage you want, release the SEARCH controls. The SHUFFLE and REPEAT buttons allow you to select various play modes. ⷠTo protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. Dubbing: Copying from deck 2 to 1 For best results, use mains power or fresh batteries. EJECT 9/ keys and insert a recorded tape into deck 2 and a suitable tape for recording in deck 1. ­ By pressing PAUSE ; on deck 1, you can omit undesired passages while deck 2 continues. ­ Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. To select and record a particular passage During CD playback, press and hold down the SEARCH 5 or 6 on the remote control (or ¡ / TM on the set). ⷠPress PLAY/PAUSE 2; to put the CD player on pause at the selected passage. ­ Recording will begin from this exact point in the track when you press RECORD 0. [. . . ] Always pick up the CD by the edge and replace the CD back in its box after use to avoid scratching and dust. ⷠTo clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. ⷠNever write on a CD or attach any stickers to it. [. . . ]