User manual PHILIPS AZ8022

[. . . ] Check if the AC power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service centre. Connect the mains lead to the wall socket. To disconnect the mains supply, unplug the set from the wall socket. [. . . ] Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. POWER SUPPLY Whenever convenient, use the AC power supply to conserve battery life. Make sure you remove the power plug from the set and wall outlet before inserting batteries. batteries (not included) · Insert 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity. Press and hold SEARCH or § until the frequency in the display starts running. tM The radio automatically tunes to a station of sufficient reception. Display shows Srch during automatic tuning. Repeat step 2 if necessary until you find the desired station. ⷠTo tune to a weak station, press or § briefly and repeatedly until you have found optimal reception. Reduce its length if the signal is too strong. Direct this aerial by turning the whole set. After all stations are stored, the first preset station will then automatically play. to listen to a preset station · Press the PRESET + , - buttons once or more until the desired preset station is displayed. Programming track numbers In the stop position, select and store your CD tracks in the desired sequence. Press SEARCH or § on the set to select your desired track number. TM Display: PROG, Prog briefly and your selected track number. (See 5) TM If you attempt to program without first selecting a track number, noSE is shown. TM Display: FULL if you try to program more than 20 tracks. Reviewing the program In the stop position, press and hold PROG until the display shows all your stored track numbers in sequence. Don't expose the set, batteries, CDs to humidity, rain, sand or excessive heat. ⷠClean the set with a dry cloth. Don't use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the set. [. . . ] cD player and CD handling · If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. ⷠThe lens of the CD player should never be touched! ⷠSudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. [. . . ]