User manual PHILIPS AZ8051

[. . . ] As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured BLACK. The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured RED. Do not connect either wires to the earth terminal in the plug which is marked by the letter "E" or by the safety earth symbol or coloured green or green-and-yellow. Before replacing the plug cover, make certain that the cordgrip is clamped over the sheath of the lead ­ not simply over the two wires. [. . . ] 2 Adjust the sound with the VOLUME and DBB (Dynamic Bass Boost) controls. 3 To switch off the set, adjust the source selector to off position. note: When the set is switched off the tuner presets will be retained in the set's memory. ­ For MW (AM) the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. TRACK ­, +10 once or more to allocate a number from 1 to 32 to this station. TM Display: disappears, the preset number and the frequency of the preset station are shown. You can erase a preset station by storing another frequency in its place. This product complies with the radio interference requirements of the European Union. Autostore Autostore automatically starts programming radio stations from preset 1. Available stations are programmed in order of waveband reception strength: FM, followed by MW (LW). 2 When your chosen track number appears, press 2 When you recognize the passage you want release PROG· TM Display shows , your selected track TM Normal playback resumes. number , and the accumulated programming time. Note: During playback of a CD, MP3-CD, programme TM If you attempt to programme without first or when SHUFFLE/REPEAT is active, searching is selecting a track number, is shown. 3 Repeat steps 1 to 2 to select and store all desired tracks in this way. Different play modes: Shuffle and Repeat TM is displayed if you attempt to programme PROG· MODE allows you to select various play more than 20 tracks. The modes can be selected or changed during 4 To play your programme, press 2;. Playback of an entire CD/ CD programme in the following sequence: Reviewing your set programme shuffle ­ all tracks are played in random order · In the STOP mode, press and hold down shuffle repeat all ­ repeats the entire disc in PROG· mODE for more than one second. Random order TM Display shows all your stored track numbers in repeat all ­ plays the whole disc continuously sequence. Repeat ­ plays the current track continuously Les modes peuvent être sélectionnés ou modifiés pendant la lecture d'un CD entier/ programme CD dans l'ordre suivant: shuffle ­ lecture de toutes les plages dans un ordre aléatoire shuffle repeat all ­ répétition de la totalité du CD dans un ordre aléatoire repeat all ­ lecture du CD total de façon continue Remarque: la lecture de CD s'arrête également lorsque: repeat ­ lecture de la plage en cours de façon continue ­ vous ouvrez le compartiment de CD; ­ vous sélectionnez le tuner comme source (TUNER); 1 Pendant la lecture, appuyez une ou plusieurs fois ­ le CD est arrivé au bout. Note: MP3-CDs may take more than 10 seconds to read. This set does not play/ support the following: 2 To open the CD door, lift the CD door at the edge ­ UDF disc format. [. . . ] Do not use cleaning agents as they may heating equipment or direct sunlight. Never write on a CD or attach any stickers to it. Minimum gap of 6 inches between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. [. . . ]