User manual PHILIPS AZ8061

[. . . ] 2 Close the compartment door, and make sure the batteries are firmly and correctly in place. If BATT LOW lights up, battery power is running low. The BATT LOW indicator eventually goes out if the batteries are too weak. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. [. . . ] 7 To switch off the set, adjust the source selector to TAPE/OFF position and check the cassette keys are released. Note: CD play will also stop when: ­ you open the CD compartment; ­ you select MW, FM or TAPE sound source; ­ the CD has reached to the end. Display indication for CD functions: ­ --: flashes when CD source just selected ­ In stop mode: total track number ­ During CD playback: 2 and current track number REPEAT/ REPEAT ALL: when the respective repeat mode is activated ­ PROGRAM: when CD programme active ­ -- and PROGRAM: flashes when programme memory full ­ Er: no disc/ error in CD operation or with the CD/ CD-(R) is blank or the disc is not finalised (see Troubleshooting) Selecting a different track During playback you can use the SEARCH buttons to select a particular track. Repeat play modes REPEAT can be selected or changed during playback in the following sequence: REPEAT ­ plays the current track continuously REPEAT ALL ­ plays the entire CD continuously If you have selected a track number in the stop or pause position, press PLAY· Press SEARCH § once briefly for the next track, or press repeatedly until the desired track number appears in the display. ⷠPress SEARCH once briefly to return to the beginning of a current track. ⷠPress SEARCH more than once briefly for a previous track. Finding a passage within a track 1 During playback, press and hold down SEARCH or §. ⷠThe CD is played at high speed and low volume. 2 When you recognize the passage you want release the SEARCH button. Note:When searching within a final track and you reach the end of the last track, the CD goes to stop mode. 1 During playback, press REPEAT once or more until the desired REPEAT mode is shown. During CD playback, press and hold down the SEARCH buttons or § on the set to find your passage. PAUSE 2; to put the CD player on pause at the selected passage. Recording will begin from this exact point in the track when you press RECORD 0. Note: If you press RECORD 0 during playback, recording starts automatically from the beginning of the current track. Recording from the Radio 1 Adjust the source selector to MW or FM to select your desired waveband. Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. Adequate ventilation with a minimum gap of 6 inches between the ventilation holes and surrounding surfaces is necessary to prevent heat buildup. ⷠThe mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. ⷠTo clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. Tape deck maintenance To ensure quality recording and playback of the tape deck, clean parts A, B and C shown in the diagram below, after approx. [. . . ] WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. English If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock. No sound No power Reconnect after a few seconds. [. . . ]