User manual PHILIPS AZ8070

[. . . ] The battery supply will be switched off when the set is connected to the mains. Batteries (optional) 1. Open the battery compartment and insert six batteries, type R20, UM1 or D-cells (preferably alkaline) with the correct polarity as indicated by the (+) and (-) symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. Remove the batteries if the set is not to be used for a long time. [. . . ] Direct the aerial by turning the whole set. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and BASS controls. To switch off the radio, adjust the source selector to the TAPE/OFF position (with the cassette keys released) VO LU ME INCR EDIB SURROUNDLE PA US E STOP 5 CD PLAYER CD DISPLAY INDICATION ­ Total track number: in stop mode ­ Current track number: during CD play. ­ SHUFFLE/REPEAT modes: when the respective mode is activated ­ PROGRAM: When active. P also appears briefly when you store a track ­ NO: no disc ­ E: error in CD operation or with the CD (see Troubleshooting) ­ F: program memory full English CD PROGRAM SHUFFLE REPEAT ALL PLAYING A CD 1. To open the CD door, press OPEN on the CD door. Insert a CD with the printed side facing up and press the CD door gently to close. TM The CD player scans the contents of the CD and the total number of tracks is displayed. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and BASS controls. To interrupt playback press PLAY/PAUSE 2;. To resume, press PLAY 2 again TM The current track number flashes in the display 7. To review your set programme · In the stop position, press and hold down CD MODE for one second or more. TM The display will show in sequence all your stored track numbers. · Start playback of your program by pressing PLAY/PAUSE 2;. Erasing a program You can erase the contents of the memory by: ­ pressing the CD door open; ­ moving the source selector position; ­ pressing STOP 9 twice during playback / in stop position · The display will show `no' briefly and PROGRAM, which disappear when the programme is cancelled. CD PROGRAM CD PROGRAM 7 CASSETTE RECORDER PLAYING A CASSETTE 1. Press STOP·OPEN 9 / to open the cassette holder and insert a cassette. Adjust the sound using the VOLUME, INCREDIBLE SURROUND and BASS controls 6. By pressing 5 or 6, fast winding of the tape is possible in both directions. To stop fast winding, press STOP·OPEN 9 /. To stop the tape, press STOP·OPEN 9 /. TM The keys are automatically released at the end of the tape, except if PAUSE ; has been activated. With the source selector in TAPE/OFF position, the set is switched off when all the cassette keys are released. English ULTRA BASS NAMIC BASS BOOS T UM E PA US E STOP -O PE N SE AR CH PLAY RECO RD General information on cassette recording · Recording is permissible insofar as copyright or other rights of third parties are not infringed. [. . . ] To resume recording, press PAUSE ; again. To stop recording, press STOP·OPEN 9 /. ULTRA BASS NAMIC BASS BOOS T UM E PA US E STOP -O PE N SE AR CH PLAY RECO RD 9 MAINTENANCE PRECAUTIONS & GENERAL MAINTENANCE · Place the set on a hard, flat surface so that the system does not tilt. · Do not expose the set, CDs, batteries or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. Adequate ventilation with a minimum gap of 15 cms between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. [. . . ]