User manual PHILIPS AZT3202/05Z

[. . . ] Portable CD Player Audio AZT3200 AZT3201 AZT3202 1 7 DIGITA L DYNAM ST S BOO IC BAS 6 5 4 3 2 8 G TUNIN DBB PROG MODE ET PRES 0 45 SE CO ND !@ S ELE C T RO OT NIC SKIP PR EC TI ON CD RE W R IT AB LE C O MP ATI BLE 9 CD FM ITAL DIGTUNER 1 # $ % QUICK START MISE EN SERVICE RAPIDE ENCENDIDO RAPIDO 1 OPEN DIGITAL DYNAMIC BASS BOOST DBB 2 MODE PRESET 2. CD REW AB RIT LE TUNING CD FM ITAL DIGTUNER CO MP AT AA LR6 UM3 IBLE 45 SECON DS ELECTRONIC SKIP PROTE CTION 1. 1. 3 CD 4 DIGITAL DYNAMIC BASS BOOST DBB TUNING CD 5 HOLDOFF MODE PRESET TAL FM DIGI NER TU COMPA TIBLE FM ITAL DIGTUNER RITA O FF · RE SU M E 45 CD SE CO ND TION S ELE C T RO NIC SKIP PROTEC REW BLE ·H OL D LIN E OU T/ VOL. 0 6 PLAY DIGITAL BOO C BASS DYNAMI ST 7 VOLUME DBB TUNING CD MODE PRESET DIGIT !!! DIGITAL DYNAMIC BASS BOOST DIGITAL DYNAMIC BASS BOOST DIGITAL DYNAMIC BASS BOOST CD TUNING DBB MODE PRESET DBB MODE PRESET DBB MODE PRESET DIGITAL FM TUNER COMPATIBLE TUNING CD TUNING COMPA TIBLE 45 NDS BLE ELECT LE RONIC RITA LE REW 45 CD SE AB RIT SKIP PROTECTION CD REWR ITAB CO ND TION S ELE C T RONIC SKIP 45 SECOND PROTEC S ELECTRONIC CD SKIP PROTECTION REW CO SECO MPAT FM ITAL DIGTUNER CD FM ITAL DIGTUNER IBLE 2 English CONTROLS / POWER SUPPLY POWER SUPPLY / GENERAL INFORMATION ECO-PLUS NiMH battery information (for versions supplied with the rechargeable ECO-PLUS NiMH battery AY 3362) Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3362. Recharging the ECO-PLUS NiMH battery on board 1 Insert the rechargeable ECO-PLUS NiMH battery AY 3362. 2 Connect the mains adapter to the 4. 5V DC socket of the player and then to the wall socket. [. . . ] · To remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. In-car use (connections supplied or optionally available) Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4. 5 V DC, positive pole to the center pin) and the AY 3501 cassette car adapter. 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4. 5V DC input socket on the set. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. Turn down the volume and connect the adapter cassette plug to LINE OUT/p on the set. Carefully insert the adapter cassette into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Decrease the volume on the set if necessary. Start playback on the set and adjust the sound with the car radio controls. Playback information · If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, nF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. · When playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. · Playback will stop if you open the CD lid. · While the CD is read, 1 -:- flashes in the display. Volume and bass Volume adjustment · Adjust the volume by using VOL E. Bass adjustment · Press DBB to switch the bass enhancement on or off y DBB is shown if the bass enhancement is activated. 2 3 4 5 6 7 · Always remove the voltage converter from the cigarette lighter socket when the set is not in use. Note: If your car radio has a LINE IN socket, it is better to use it for the car radio connection instead of the adapter cassette. Connect the signal lead to this LINE IN socket and to LINE OUT/p on the set. FEATURES Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. yPlayback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. yPlayback starts with the selected track. [. . . ] · For in-car use, check that the car ignition is on. The indication no diSC is displayed · Check that the CD is clean and correctly inserted (label-side upward). · If your lens has steamed up, wait a few minutes for this to clear. The indication nF diSC is displayed · CD-RW (CD-R) was not recorded properly. [. . . ]