User manual PHILIPS AZT9500

[. . . ] Portable CD Player AZT9500 Portable CD Player English Français Español Nederlands Meet Philips at the Internet http://www. philips. com CLASS 1 LASER PRODUCT 3140 115 2899. 1 Printed in China 6 7 8 0 4 5 3 2 1 9 !@ # ^ $ % & * ) ( 1 QUICK START MISE EN SERVICE RAPIDE 1 OPEN 2 AA LRG UM3 3 CD 4 5 HOLDOFF 6 PLAY 7 VOLUME !!! English CONTROLS / POWER SUPPLY POWER SUPPLY / GENERAL INFORMATION ECO-PLUS NiMH battery information (for versions supplied with the rechargeable ECO-PLUS NiMH battery AY 3362) Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3362. Recharging the ECO-PLUS NiMH battery on board 1 Insert the rechargeable ECO-PLUS NiMH battery AY 3362. 2 Connect the mains adapter to the 4. 5V DC socket of the player and then to the wall socket. [. . . ] 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. 2 Plug the voltage converter into the cigarette lighter jack (only for 12 V car battery, negative grounding), then connect the wired end with 4. 5V DC input jack on the set. 3 If necessary, clean the cigarette lighter jack to obtain a good electrical contact. 4 Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set. 5 Carefully insert the cassette adapter into the car radio's cassette compartment. 6 Make sure the cord does not hinder your driving. Start playback on the set and adjust the sound with the car radio controls. · Always remove the voltage converter from the cigarette lighter jackwhen the set is not in use. Note: If your car radio has a LINE IN jack, it is better to use it for the car radio connection instead of the cassette. adapter. Connect the signal lead to this LINE IN jack and to LINE OUT/p on the set. 12 V DC Playback information · If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, nF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. · When playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. · Playback will stop if you open the CD lid. · While the CD is read, 1 -:- flashes in the display. 4, 5 V DC Volume and bass Volume adjustment · Adjust the volume by using VOL E. OPE N VOL Bass adjustment · Press DBB to switch the bass enhancement on or off. y is shown if the bass enhancement is activated. FEATURES Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. yPlayback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. yPlayback starts with the selected track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. ySearching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. [. . . ] · If your lens has steamed up, wait a few minutes for this to clear. The indication nF diSC is displayed · CD-RW (CD-R) was not recorded properly. The indication HOLD is on and/or there is no reaction to controls · If HOLD is activated, then deactivate it. Disconnect power or remove batteries for a few seconds. [. . . ]