User manual PHILIPS BDL3210Q

[. . . ] BDL3210Q BDL4210Q BDL4610Q www. philips. com/welcome User Manual (English) BDL3210Q / BDL4210Q / BDL4610Q Safety Instructions Warnings and Precautions KNOW THESE SAFETY SYMBOLS CAUTION:  REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). TO REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. Note to CATV system installers: This reminder is provided to call CATV system installer’s attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. CAUTION:  FCC/CSA regulations state that any unauthorized changes or modifications to this equipment may void the user’s authority to operate it. [. . . ] Increase and decrease volume respectively. N/A. FORMAT BACK 22 23 24 2 MENU Open or close main menu. Key number on your remote controller changes. Key number on your remote controller changes. Key number on your remote controller changes. N/A. 3 Blu-ray IPTV DVD TV 4 25 VOL 26 0-9 27 28 +/- 5 numeric buttons 6 Open on screen menu. Open sound menu. SMART SMART 6 BDL3210Q / BDL4210Q / BDL4610Q 29 HDMI1 30 HDMI2 31 HDMI3 Select the HDMI1 SOURCE. N/A. 32 VGA 33 AV1 34 AV2 35 CVI Select the VGA SOURCE. Connected USB device can be identified automatically. Select to browse the contents of the USB device in the main menu. No hotkey design is required for this on the remote control unit. 36 USB 7 BDL3210Q / BDL4210Q / BDL4610Q 2. 3. 2. Inserting the batteries in the remote control The remote control is powered by two 1. 5V AAA batteries. To install or replace batteries: 1. Press and then slide the cover to open it. 2. Align the batteries according to the (+) and (–) indications inside the battery compartment. 3. Replace the cover. Caution: The incorrect use of batteries can result in leaks or bursting. Be sure to follow these instructions: • Place “AAA” batteries matching the (+) and (–) signs on each battery to the (+) and (–) signs of the battery compartment. • Do not combine new batteries with used ones. It causes shorter life or leakage of batteries. • Remove the dead batteries immediately to prevent liquid from leaking in to the battery compartment. Don’t touch exposed battery acid, as it can damage your skin. NOTE:  you do not intend to use the remote control for a long period, remove the batteries. If 2. 3. 3. Handling the remote control • Do not subject to strong shock. • Do not allow water or other liquid to splash the remote control. [. . . ] 2. The main power switch on the back of the display is not switched on. 3. The selected input has no connection. 2. Make sure the power switch is switched on. 3. Connect a signal connection to the display. Symptom No picture is displayed Interference displayed on the display or audible noise is heard Color is abnormal Picture is distorted with abnormal patterns Caused by surrounding electrical appliances or fluorescent lights. [. . . ]