User manual PHILIPS BDL6531E

[. . . ] BDL6531E www. philips. com/welcome EN User manual Cleaning and troubleshooting User Manual BDL6531E SAFETY AND TROUBLESHOOTING INFORMATION Safety precautions and maintenance WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards. Read and follow these instructions when connecting and using your display: Operation: • Keep the display out of direct sunlight and away from stoves or any other heat sources. • Remove any object that could fall into the ventilation holes or prevent proper cooling of the display’s electronics. • Do not block the ventilation holes on the cabinet. [. . . ] Once enabled, the image brightness will be adjusted automatically when the ambient lighting conditions change. Use the PLUS/MINUS button to make selection. SMART CONTRAST Turned on, this function helps enhance image contrast when displaying dark scenes. Use the PLUS/MINUS button to make selection. VIDEO SOURCE Select a video input source. Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle between • DVI-D • HDMI • VGA • COMPONENT • S-VIDEO • VIDEO PICTURE RESET Reset all settings in the PICTURE menu. Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to make selection. Select YES and press the SET button to restore settings to factory preset values. Press the EXIT button to cancel and return to the previous menu. RETURN TO THE CONTENTS User Manual BDL6531E 4. 2. 2. SCREEN MENU S CR EE N H P O SI TI ON V P O S IT I O N CL OCK CL OCK P HAS E ZOOM M O DE CU S TOM ZOO M S CR EE N RE S E T 50 50 16 14 F ULL Se l A djus t E nter Ba ck Qui t H POSITION Note: For VGA input only. Adjust the horizontal placement of the picture. Press the PLUS button to move the image to the right, or MINUS to move the image to the left. Adjust the vertical placement of the picture. Press the PLUS button to move the image up, or MINUS to move the image down. Press the PLUS button to expand the width of the image, or MINUS to shrink it. Adjust to improve the focus, clarity and stability of the image. ZOOM MODE The pictures you receive may be transmitted in 16:9 format (widescreen) or 4:3 format (conventional screen). 16:9 pictures sometimes have a black band at the top and bottom of the screen (letterbox format). This function allows you to optimize the picture display on screen. The following zoom modes are available: • FULL - This mode restores the correct proportions of pictures transmitted in 16:9 using the full screen display. • NORMAL - The picture is reproduced in 4:3 format and a black band is displayed on either side of the picture. • DYNAMIC - Fill the entire screen by stretching 4:3 pictures non-proportionally. [. . . ] • Do not place anything made from rubber or PVC near the cabinet for any extended periods of time. RETURN TO THE CONTENTS User Manual BDL6531E 7. 2. TROUBLESHOOTING Symptom No picture is displayed Possible Cause 1. The main power switch on the back of the display is not switched on. The display is in standby mode with VGA. [. . . ]