User manual PHILIPS CD RCR 3 PIECE AZ240717

[. . . ] If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note:The severed plug must be disposed to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). 0 As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: ­ Connect the blue wire to the terminal marked N or coloured black. [. . . ] WAIT lights up. The display shows the total remaining time for the selected recording. fRECORDg lights continuously. The display counts down through the finalization. On completion, the total number of tracks and the total time recorded appears on the display. For CDR(W), 0 4 5 Notes: Finalizing will take at least 2 - 4 minutes. During finalization, the CD recorder accepts no operating commands. When a CDR is finalized no more recordings can be added. r changes to d on display. 18 xp CDR 775/00. 1 english 10-07-2001 13:19 Pagina 19 Adjusting recording level Set the recording level, if necessary, to make compilations from different discs with equalized volume levels. Prerecorded CD's often have different volume levels. When playing back your compilation you could hear these differences in volume between tracks. Amplifying a of digital audio information stream will distort the audio signal. This means that digital signals can only be decreased in volume to obtain equal audio levels for different tracks. Our advise is to record all tracks on -3dB (or lower if needed). In this way it is possible to - increase (0 dB is maximum) the volume level for those tracks with a weaker signal, - decrease (-3 dB or less) the volume level for those tracks with a stronger signal. For pre-listening you need to make a test recording with a CDRW disc in the left disctray: Some external analog sources have such high output levels, that you may need to adjust the recording level to ensure good quality recordings without distortion. If you wish to switch Auto Track off or on: Press STORE/MENU. Rotate the EASY JOG/ENTER key to select the AUTO TRACK submenu. Turn the EASY JOG/ENTER key to select Auto track ON or OFF. During analog and digital recording, you can always insert track numbers manually by pressing TRACK INCR. on the remote control. The minimum track length is 4 sec. Track numbers cannot be changed after recording. Press SOURCE repeatedly until ANALOG lights up and ANALOG appears on the display. With the CD recorder stopped press REC TYPE five times to select REC EXT MAN. The display shows REC EXT MAN followed by WAIT. If MANUAL starts to flash you can insert track increments manually (AUTO TRACK is set to OFF). After a few seconds PRESS RECORD followed by the remaining time and track number appear on the display. You can record a 3-second silence at the start of a track by pressing PLAY/PAUSE 2; on the CD recorder before starting the recording. Recording To start recording, press RECORD on the CD recorder and immediately start the turntable. [. . . ] Select the album title you wish to erase. ERASE MEMORY will appear on the display. Press the EASY JOG/ENTER key to confirm the erasure of the text for that particular disc. Press STORE/MENU to return to the submenu or STOP 9 to exit. [. . . ]