User manual PHILIPS CD SOUNDMACHINE DYNAMIC BASS BOOST AZ1300

[. . . ] · Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms. The typeplate is located on the bottom of the set BASIC FUNCTIONS Switching power on/off: Save energy Whether you are using mains or battery supply, to avoid unnecessary energy consumption always adjust the source selector to off. General operation 1 To select your sound source adjust the source selector to CD/TUNER/OFF. 2 Adjust the sound with the VOLUME and DBB (Dynamic Bass Boost) controls. [. . . ] 2 Press PROG MODE to activate programming. (See 5) 3 Press PRESET + or ­ once or more to allocate a number from 1 to 20 for FM or 1 to 12 for AM. 4 Press PROG MODE again to confirm the setting. TM Display: prog disappears, the preset number and the frequency of the preset station are shown. (See 3) 5 Repeat steps 1-4 to store other stations. · You can erase a preset station by storing another frequency in its place. CD PLAYER CD Player Display indication for CD functions ­ CD open: CD door open (See 6) ­ disc: CD inserted (See 7) ­ In stop mode: total track number and total playback time ­ During CD playback: elapsed playback time of current track and current track number ­ Pause: elapsed playback time freezes and flashes (See 8) ­ shuffle/ repeat modes: when the respective mode is activated ­ prog: when CD program active); prog also appears briefly when you store a track (See 9) ­ no sel: program activated but no tracks selected (See 0) ­ full: program memory full (See !) ­ no prog: program cancelled (See @) ­ no disc: no disc/ error in CD operation /CD-R(W) is blank or the disc is not finalized (See # + Troubleshooting) Playing a CD This CD-player can play Audio Discs and CDRecordables. Do not try to play CD-Rewritables, a CD-ROM, CDi, VCD, DVD or computer CD. 2 To open the CD door, lift the CD door at the edge marked LIFT TO OPEN. 3 Insert a CD or CD-R with the printed side facing up and press the CD door gently close. 4 Press 2; on the set to start playback. Note: CD play will also stop when: ­ you open the CD compartment; ­ you select TUNER sound source; ­ the CD has reached to the end. (See 9) TM If you attempt to program without first selecting a track number, no sel is shown. (See 0) 3 Repeat steps 1 to 2 to select and store all desired tracks in this way. TM full is displayed if you attempt to program more than 20 tracks. (See !) 4 To play your program, press 2;. Reviewing your set program MAINTENANCE & SAFETY Precautions & General Maintenance (See $) · Don't expose the set, batteries, CDs to humidity, rain, sand or excessive heat. · Clean the set with a dry cloth. Don't use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the set. · Place the set on a hard and flat surface so that the system does not tilt. Make sure there is good ventilation to prevent the set overheating. · Apparatus shall not be exposed to dripping or splashing. · Do not place any sources of danger on the apparatus (e. g. liquid filled objects, lighted candles). [. . . ] To clean, dust the position compartment with a soft dry cloth. TM Display: shows no prog briefly when the · To clean the CD, wipe in a straight line from the program is cancelled. (See @) center towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. · Never write on a CD or attach any stickers to it. Know these safety symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For Customer Use Enter below the Serial No. [. . . ]