User manual PHILIPS CD445

[. . . ] Note: If BACK is pressed, the handset will show the country selection screen again. EN Welcome mode Before using your CD 130, you need to configure it according to the country of use. After a few minutes of charge, the Welcome screen appears. to confirm the country that suits you. Your phone is ready to be used. If you need to re-configurate your CD 130, see page 32. [. . . ] is shown, press confirmation beeptone. Delete whole phonebook list when in idle mode 1. In idle mode, press Press , PHONEBOOK is shown. You will hear a long and press Down Press , DELETE?is shown, press confirmation beeptone. 20 Call log This feature is available if you have registered to the caller identification service with your operator. The call log stores the last 20 external calls received : - network message service information (subject to a subscription with your operator). EN Accessing / exiting the call log 1. Press Up Press Press and scroll to select an entry. to view the details. to exit the call log. Consulting the call log The screen can either display : · the caller's number* · the caller's name (if known in the phonebook)* · UNKNOWN CALL if it is an unidentified call** * Subject to a subscription with your operator. ** Unlisted numbers, withheld caller identification. You can display, the phone number, the time and date of the call by pressing and date depends on the network. Time Calling a number from the call log 1. and scroll to select an entry. Saving a Call log number into the phonebook 1. to select the appropriate setting (OFF or ON ONCE or EN 4. If you select ON ONCE or ON DAILY : Enter the time and press to confirm. The alarm rings for at most 1 minute and is shown in idle mode. Note: When the alarm rings, press any key to stop the alarm. To set the alarm tone 1. Press Press and press Down and press Down to reach CLOCK/ALARM. to reach ALARM TONE. Press , scroll to select the appropriate setting (MELODY 1 or MELODY 2 or MELODY 3). Press to confirm. Personal settings To set the handset ringer volume or silence mode (Ringer OFF) 1. , RING VOLUME is , HANDSET TONE is shown, press 3. 4. Press , scroll to select the appropriate setting (HIGH or MEDIUM or LOW or RINGER OFF). Press to confirm. 25 EN Personal settings WARNING : When the handset rings during an incoming call, please do not hold the handset too close to your ear as the volume of the ringing tone may damage your hearing. To select the handset ring melody 1. Press and press Down to reach PERSONAL SET. and scroll Down to Press , HANDSET TONE is shown, press reach RING MELODY. [. . . ] SOLUTIONS · Disconnect and connect the base station power supply. · Remove and place back the handset batteries. · Follow the procedure to register a handset (page 30). · Wait until it is available. · Maximum number of handsets (5) has been reached. [. . . ]