User manual PHILIPS CD634

[. . . ] AVOID DIRECT EXPOSURE TO BEAM NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can be used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning this equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : - reorient or relocate the receiving antenna. [. . . ] Examples: - CD-player is connected with its digital out connector directly to the digital in connector of your CD-recorder: connection is DIGITAL I. - CD-player is connected with its analog out connectors directly to analog in connectors of your CD-recorder: connection is ANALOG - Turntable is connected with its analog out connectors to amplifier/receiver which is connected to the analog in connectors of your CD-recorder: connection is ANALOG DIGITAL I, OPTICAL I or ANALOG lights up and DIGITAL 1, OPTICAL or ANALOG will appear on the display. 3 With the CD recorder stopped, press REC TYPE to select REC DISC for recording of an entire CD or a program of tracks. d and sync start to flash and the display shows the selection. If the input label DIGITAL I or OPTICAL also flashes, switch on the external source or check the digital connection. Notes: If you are recording from a digital source (OPTICAL or DIGITAL 1) and want to finalize the CD automatically after recording, press RECORDING TYPE until the option MAKE CD is selected. If you planned to record a compilation of tracks, be sure to have programmed a selection of tracks on the CD-player or CD-changer from which you are going to record. 1 2 Place an unfinalized CD(RW) disc, absolutely free of scratches and dust particles in the CD recorder tray. Press SOURCE repeatedly to select the ANALOG input ANALOG lights up and ANALOG will appear on the display. With the CD recorder stopped, press RECORDING TYPE three times to select REC MANUAL. d starts to flash and the display shows PRESS RECORD. Start the source by pressing PLAY/PAUSE 2;. If, however, you start the source during a track, recording will start at the beginning of the next track or after 2. 7 seconds of silence in analog recordings. The EASY JOG/ENTER key can be used to adjust the recording level. The recorder stops automatically in case of digital recording from a CD. Recordings from DAT, DCC or analog sources will only stop after 20 seconds of silence. To stop recording manually, press STOP 9 on the CD recorder. sync goes out and the display will show UPDATE for several seconds. Finalizing If you want to play the recorded CDR(W) on a normal CD player, you must first finalize the disc. Please note that you cannot add anymore tracks on a finalized CDR. See Finalizing CDR and CDRW discs. 20 Recording a single track English 0 0 0 0 2 1 0 0 0 2 xp CDR 600/17 English 20-03-2001 13:27 Pagina 21 Recording 1 2 Preparing Place an unfinalized recordable disc, absolutely free of scratches and dust particles in the CD recorder tray. Press SOURCE repeatedly to select the type of connection you made to your source of recording. Examples: - CD-player is connected with its digital out connector directly to the digital in connector of your CD-recorder: connection is DIGITAL I. [. . . ] Press the EASY JOG/ENTER key to confirm the erasure of the text for that particular disc. Press STORE/MENU to return to the submenu or STOP 9 to exit. Notes: If there are no discs in the memory, the message MEMORY EMPTY will appear on the display. When the text memory of your CD recorder is full, the message MEMORY FULL will appear, followed by FINALIZE CD. [. . . ]