User manual PHILIPS CDC925-00S

[. . . ] Allow to cool before putting on or taking off parts, and before cleaning the appliance. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or adjustment. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons. [. . . ] This must be pressed and turned using the supplied key only. ENGLISH 15 Press and turn the pin one notch at a time and brew 2-3 cups of coffee; this is the only way to notice differences in grind. The reference marks inside the coffee bean hopper indicate the grind setting. There are 5 different grind settings to choose from with the following references: 1 2 1 - Coarse Grind: Lighter taste, for dark roasted coffee blends; 2 - Fine Grind: Bolder Taste, for light roasted coffee blends. "Aroma" Adjustment: Select Your Favourite Amount Choose your favourite coffee blend and adjust the amount of coffee to be ground until they meet your personal taste. The machine is set-up to adjust the amount according to the coffee to be ground. Four choices are possible by pressing and releasing the " medium or strong aroma, and pre-ground coffee. " button: Mild, Green Selection can be made when the beans appear on the display. Each time the " " button is pressed and released, the aroma changes by one degree, according to the selected amount: = Mild aroma = Medium aroma = Strong aroma Note: Selection must be made prior to select coffee. The system sets the aroma according to the personal taste of the user. After selecting "Strong aroma", the function for brewing coffee with preground coffee is displayed. Green This selection is displayed by the icon on the side. Refer to the relevant section to use this function. 16 ENGLISH Brewing Coffee Note: Should the machine not brew coffee, make sure that the water tank contains water. Before brewing coffee check the lights on the display and make sure the water tank and coffee bean hopper are full. Before brewing coffee, adjust the height of the dispensing spout according to your needs and select the aroma or pre-ground coffee. Adjusting the Dispensing Spout Most cups on the market can be used with this coffee machine. This amount may be reprogrammed according to your taste. Each button may be individually programmed for a specific brew setting. Note: As an example, the following procedure describes the programming of the " " button, which is usually associated with espresso coffee. 1 Place a cup under the dispensing spout. 2 Press and hold the" Green " button until the "MEMO" icon is displayed. The machine is now programming. The machine begins the brewing phase. The "STOP" icon is displayed. Green 3 From now on, press the " fee is reached in the cup. " button when the desired amount of cof- Now the " " button has been programmed; each time it is pressed and released, the machine will brew the same amount that has just been set. ENGLISH 19 Hot Water Dispensing Green Before dispensing hot water, check that the machine is ready to use and the following icon is displayed. When the machine is ready to brew coffee, proceed as follows: 1 Place a container under the steam wand (Pannarello, if supplied). Green 2 Press the " " button. The following icon is displayed. 3 Press the " " button to start dispensing hot water. 4 Pour the desired amount of hot water. To stop the hot water dispensGreen ing press the " ing mode. " button. The machine returns to the normal operat- Note: It may happen that, even though the " " button has been pressed, hot water does not come out and the following icon is displayed. Simply wait until the end of the warm-up phase so that hot water can be dispensed from the Pannarello. Warning: At the beginning, short spurts of hot water may come out: Danger of scalding. The hot water wand may reach high temperatures: Do not touch it with bare hands. Orange 20 ENGLISH Steam Dispensing / Preparing a Cappuccino with Pannarello Steam may be used to froth milk for a cappuccino, as well as to heat other beverages. [. . . ] In this case wait until the machine performs a self-adjusting operation as described in section "Saeco Adapting System". Please contact an authorised service centre for any problems not covered in the above table or when the suggested solutions do not solve the problem. 35 Technical Specifications The manufacturer reserves the right to make changes to the technical specifications of the product. Nominal voltage - Power rating - Power supply . See label on the inside of the service door Housing material. Thermoplastic material Size (w x h x d) (mm) . [. . . ]