User manual PHILIPS CDR 765

[. . . ] You must have proof of purchase to receive warranty service. A sales receipt or other document showing that you purchased the product is considered proof of purchase. Please check your owner's manual before requesting service. Adjustments of the controls discussed there may save you a service call. [. . . ] The two ways to make recordings are described below: - Digital dubbing (normal or high-speed dubbing) - Recording from an external source: - Digital - Digital with synchronized start using external CD player - Analogue · If the disc is a CD-RW and is already finalized you must unfinalize it first (page 17). ⷠIf the disc already contains recordings, the CD recorder will automatically search for the end of the last track, so that you can start recording from there. ⷠThere must be at least 7 seconds of recording time left on the disc, or you will not be able to activate the record standby mode. ⷠIf the display indicates COPY PROHIBIT, no digital recording can be made of the source material. Recording will not start or will stop after 4 seconds. ⷠThe Serial Copy Management System (SCMS) only allows digital recording under specific conditions: - It is not possible to make a digital copy from a digital copy. - Analogue recording is always possible!- The number of recordings from the original is unlimited. Digital recordings can be made from CDs (or other sources with an output Sample Frequency of 44. Recordings from DAT or DCC players will not stop automatically. Use the dubbing feature for high-speed recording from the CD Player deck to the CD Recorder deck. Some comments about dubbing: - A complete disc or program can be copied at high speed D (DUBB). - Single tracks or programs can be copied at normal speed D (DUBB-1). Preparing for normal and high-speed dubbing 1 Make sure that the recording disc is completely free of scratches and dust particles. 2 If necessary, press the DUAL button to switch off the DUAL mode on the display. Start high-speed dubbing (Disc copy) 1 To record a complete disc or program, press DUBB repeatedly until: < DUBB appears and DUBB flashes on the display. After some time, BUSY and the track number will appear on the display. If you want to play back the recorded CD-R disc on the CD Player deck or on any other regular CD player, it must be finalized first. The minimal track length must be four seconds, otherwise a pause will be added to the track. After dubbing, UPDATE will appear on the display for several seconds. To check the (remaining) recording time, press Display (this can be done during recording). The minimal track length must be four seconds, otherwise a pause will be added to the track. [. . . ] < On the display, the track number appears briefly, followed by the total programmed tracks and total program time. - To add more tracks to the program, repeat steps 1 through 6. - If you try to store more than 30 tracks, FULL appears on the display 2 Press STOP again to clear the program. If you think your CD Recorder/Player is defective, it is wise to check this list first, and run the diagnostic program. [. . . ]