User manual PHILIPS CDR778/01C

[. . . ] Audio CD Recorder CDR778 · Instructions for use · Mode d'emploi · Instrucciones de manejo · Bedienungsanleitung · AUSTRALIA Philips Product Warranty (FOR AUSTRALIA ONLY) Warranty conditions valid for Colour Television, Video Cassette Recorders, CD Recordable, DVD Players, Audio Systems, and Portable Audio. The benefits given to the purchaser by this warranty are in addition to all other rights and remedies which the purchaser has in respect of the product under the Trade Practices Act or other Commonwealth or State Law. Philips Consumer Electronics warrants its products to the purchaser as follows and subject to the stated conditions. 12 months free service Conditions of warranty 1. All claims for warranty service should be made to your nearest Philips Authorised Service Center. [. . . ] · To record a 3-second silence at the start of a track, press PAUSE on the CD recorder before starting the source. · To check the total remaining recording time, press DISPLAY on the CD recorder. (This can also be done during the recording. ) 2 To stop recording, press STOP on the CD recorder. · If STOP was pressed within 3 seconds after RECORDINGRECORD, no recording will take place. · To interrupt recording, press PAUSE on the CD recorder. ( A new track will always be made. ) After recording the display will show UPDATE for several seconds. Note: With AUTO TRACK ON, the recorder will stop and go to REC STANDBY for 1 minute and then goes to Stop mode automatically. Recordings from DAT, DCC or recordings made analogously will stop after 20 seconds silence. With AUTO TRACK OFF, the auto stop mode is disabled. SYNC MANUAL DIGITAL I OPTICAL I ANALOG CD RECORD CHANGER CD RW RW PROG SHUFFLE ALL REPEAT SCAN TRACK · When Auto Track is On (default setting), track numbers will automatically be increased during recording. · To switch off the Auto Track function you have to enter Menu mode. If you wish to increase track numbers manually, press TRACK INCR(ement) on the remote control. ON (AUTO): The track increments are automatically taken over from the digital source material or after 2. 7 seconds silence during analogue recording. OFF (MANUAL): While recording track numbers can be incremented manually by pressing TRACK INCR(ement) on the remote control. (Minimum track length is 4 sec. ) (This can also be done in Auto track ON mode. ) · Track numbers cannot be changed after recording. Note: Auto track works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard. 3 With the recorder stopped, press RECORDING-TYPE five times to enter the Manual Record standby mode. Important: If you want to play the recorded CDR disc on any regular CD player, it must first be finalised. Finalised CDRW discs play only on CDRW compatible CD players. 19 RECORDING For recording from CD changers always use REC EXT Autostart recording from external CD player DISC. · If, however, you start the source during a track, CD-SYNC recording starts at the beginning of the next track or after 2. 7 seconds of silence in analogue recordings. · To check the remaining recording time on the CDR(W), press DISPLAY. (This can also be done during recording) CDR English CD-SYNC OPEN/CLOSE PLAY/PAUSE STOP TYPE RECORDING RECORD FINALIZE ERASE EXT SOURCE · The EASY JOG/ENTER key can be used to adjust the recording level. AUDIO CD PLAYBACK PROG SHUFFLE DISPLAY SCROLL REPEAT DJ MODE · The recorder stops automatically. 2 To stop recording manually, press STOP on the CD recorder. UPDATE lights up and SYNC and · If STOP 9 was pressed within 3 seconds after pressing PLAY, no recording will take place. [. . . ] · text memory full (MEMORY FULL / FINALIZE CD). When a CDRW has to be unfinalised for recording. Erase text for other disc(s) or finalise other disc(s) to obtain memory space. · total remaining time not sufficient, try programming tracks (see programming). [. . . ]