User manual PHILIPS CGA5722

[. . . ] Register your product and get support at www. philips. com/welcome CGA5722 EN Wireless ADSL Modem Router Table of contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 1. 7 2 2. 1 2. 2 2. 3 2. 4 Important Safety information Network range & speed information Conformity Recycling and disposal FCC Radiation Exposure Statement Software licenses Disclaimer Your Wireless ADSL Modem Router What's in the box What else will you need 2 2 2 2 2 2 2 2 3 4. 11 3 3 5 6 Technical data Frequently asked questions 18 20 SET UP WiZARD 17 4. 6 4. 6. 1 4. 6. 2 4. 6. 3 4. 6. 4 4. 7 4. 8 4. 9 4. 10 Advanced settings webpages NAT Maintenance System SNMP UPNP QoS DDNS Routing 13 13 14 14 15 15 15 16 16 Overview of the front side of the wireless ADSL modem router 4 Overview of the rear side of the wireless ADSL modem router Getting started Install Connect Install a WiFi device Install a Wireless USB adapter SNU 5600 Install another WiFi device Configuring the Wireless Modem Router Log on the webpages Webpages' menu structure ADSL/Internet Settings webpages ADSL status ISP settings Parameters DNS Security webpages Firewall Wireless Security Home Network Settings webpages Status Network settings Wireless 4 5 5 5 6 6 6 7 7 7 7 7 8 8 8 8 8 10 11 11 11 11 3 3. 1 3. 2 3. 3 3. 4 3. 5 4 4. 1 4. 2 4. 3 4. 3. 1 4. 3. 2 4. 3. 3 4. 3. 4 4. 4 4. 4. 1 4. 4. 2 4. 5 4. 5. 1 4. 5. 2 4. 5. 3 Table of contents 1 1 Important Take time to read this user manual before you use your Wireless ADSL Modem Router. It contains important information and notes regarding your Wireless ADSL Modem Router. 1. 1 Safety information !Warning · This equipment must only be powered with the Power Adapter provided in the box. · For use only with power supply "Leader: MU12-2120100-B2" and/or "Jentec: AH1212-C". [. . . ] Note The passphrase can consist of up to 32 alphanumeric characters. To manually configure the encryption key, enter five hexadecimal pairs of digits for each 64-bit key, or enter 13 pairs for the single 128-bit key. (A hexadecimal digit is a number or letter in the range 0-9 or A-F). Note that WEP protects data transmitted between wireless nodes, but does not protect any transmissions over your wired network or over the Internet. WPA: Access Control allows users to define the outgoing traffic permitted or not-permitted through the WAN interface. The default is to permit all outgoing traffic. WDS: Wi-Fi Protected Access (WPA) combines temporal key integrity protocol (TKIP) and 802. 1x mechanisms. It provides dynamic key encryption and 802. 1x authentication service. 802. 1x: If the signal strength of a single wireless base station is not sufficient due to a large coverage area or attenuation due to walls, with WDS the range of a wireless base station can be extended. All base stations in a Wireless Distribution System must be configured with the same radio channel, and encryption type (WEP/WPA) if that is used. Note The WDS feature is not completely specified in IEEE or Wifi standards. Therefore it cannot be guaranteed that WDS will work with products of different vendors. WEP: If 802. 1x is used in your network, then you should enable this function for the ADSL Wireless Base Station. These parameters are used for the ADSL Wireless Base Station to connect to the authentication server. If you use WEP to protect your wireless network, you need to set the same parameters for the ADSL Wireless Base Station and all your wireless clients. 12 Configuring the Wireless ADSL Modem Routerr 4. 6 Advanced settings webpages 4. 6. 1 NAT For example, if you set Type/Public Port to TCP/80 (HTTP or web) and the Private IP/Port to 192. 168. 2. 2/80, then all HTTP requests from outside users will be transferred to 192. 168. 2. 2 on port 80. Therefore, by just entering the IP address provided by the ISP, Internet users can access the service they need at the local address to which you redirect them. A list of ports is maintained at the following link: http://www. iana. org/assignments/ports-numbers Special Applications Network Address Translation allows multiple users to access the Internet sharing one public IP. Address Mapping: Some applications require multiple connections, such as Internet gaming, video-conferencing, and Internet telephony. These applications may not work when Network Address Translation (NAT) is enabled. If you need to run applications that require multiple connections, use these pages to specify the additional public ports to be opened for each application. NAT Mapping Table: Allows one or more public IP addresses to be shared by multiple internal users. This also hides the internal network for increased privacy and security. Enter the Public IP address you wish to share into the Global IP field. [. . . ] However, if you manually configure IP address on the LAN, verify that the same network address and subnet mask are used for both the ADSL Wireless Base Station and any attached LAN devices. The Wireless network is often interrupted. · Move your Wireless PC closer to the ADSL Wireless Base Station to find a better signal. If the signal is still weak, you can change the angle of the antenna. [. . . ]