User manual PHILIPS CITY LINE

[. . . ] electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Preparing for use Connecting accessories Hose 1 To connect the hose to the appliance, push it into the appliance and turn it clockwise (Fig. 2 To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance. [. . . ] The nozzle can be turned 360 degrees to 4 different positions, allowing you to vacuum large areas as well as hardto-reach places in an easy way. When the nozzle is positioned lengthwise, the suction power is concentrated at the front side of the nozzle (Fig. -- To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the indicated spot. Then turn the tube until the nozzle is in the required position (Fig. 1 Connect the Reach & Clean nozzle to the tube. 2 With the nozzle positioned breadthwise and the brush strip folded out, you can vacuum large hard floor areas. Turn the tube until the brush strip pops out of the nozzle housing and the nozzle is positioned breadthwise (Fig. 3 With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum small hard floor areas. Turn the tube 90 degrees anticlockwise until the nozzle is positioned lengthwise with the brush strip still folded out of the nozzle housing (Fig. 4 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum large soft floor areas. Turn the tube 90 degrees anticlockwise again to position the nozzle breadthwise and to make the brush strip disappear into the nozzle housing (Fig. 3 Pull the cardboard tag upwards to remove the full dustbag from the holder. 4 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder. If you have not inserted a dustbag, you cannot close the dustbag compartment cover. Replacing filters Motor Protection Filter Replace the Motor Protection Filter once a year. 1 Switch off the appliance and open the cover. 2 Insert a new filter into the holder with the white side pointing towards the dustbag compartment (Fig. Super Clean Air Filter (specific types only) Replace the Super Clean Air Filter every 6 months. 1 Open the grille at the back of the appliance and remove it (Fig. Place the bottom edge of the new filter properly behind the ridges on the inside of the grille (1). Then push the top of the filter down into the grille (2) (Fig. 3 Reattach the grille to the vacuum cleaner. [. . . ] By doing this, you help to preserve the environment (Fig. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. Com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. [. . . ]