User manual PHILIPS CLOCK RADIO AJ3144

[. . . ] A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. [. . . ] 2 ALARM indicator - lights up when alarm activated. 3 SLEEP - activates the radio for sleep function 4 Clock control - CLOCK : to run on clock time - SET ALARM : sets the alarm time - SET TIME : sets the clock time - HR/MIN : adjusts the hours/ minutes for the clock and alarm times 5 SLEEP OFF /REPEAT ALARM - switches off the radio sleep function - switches off the active alarm for a 8-9 minute period 6 Frequency indicator - shows the radio frequency of your selected waveband 7 TUNING - tunes to radio stations 8 BAND - select FM/AM waveband 9 VOLUME - adjusts the sound level 0 ALARM RESET - stops the active alarm for 24 hours !DISPLAY - show the clock/ alarm times and status of the set @ RADIO OFF / ON - switches the radio off/on # ALARM ­ OFF switches off the alarm ­ RAD activates the radio for alarm ­ BUZ activates the buzzer for alarm $ Battery door - opens to store a 9 volt 6F22 type battery (not included) for clock memory backup % Power cord - for power supply and to improve FM reception INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e. g. The complete clock radio and display illumination will be switched off. As soon as the power supply returns, the display will indicate the correct time. 1 Remove the battery door to insert a 9 volt 6F22 type battery (not included) for backup. NOTE: If no backup battery is installed or the power interruption is prolonged, you will need to set the clock and alarm times again. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press ALARM RESET during the alarm call. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: · Adjust ALARM to OFF position. REPEAT ALARM This repeats your alarm call at 8-9-minute intervals. 1 During the alarm call, press SLEEP OFF /REPEAT ALARM. 2 Repeat if desired for up to 1 hour and 59 minutes. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a fixed period of 59 minutes. This allows you to lie back, listen and fall asleep. Setting SLEEP 1 Check that the clock control is in CLOCK position. 3 Press SLEEP to activate the sleep function. TM To cancel sleep, press SLEEP OFF /REPEAT ALARM. PHILIPS LIMITED WARRANTY MAINTENANCE 90 Days Free Product Exchange WHERE WARRANTY EXCHANGE IS AVAILABLE: Exchange is available in all countries where Philips officially distributes the product. In countries where Philips does not distribute the product, the local Philips organization will attempt to exchange the product, although there may be a delay if the appropriate product is not readily available, or special customs processes are implied. [. . . ] Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. 2. This device must accept any interference received, including interference Note:The exchange model supplied will be the most compatible one in Philips current inventory. Shipping of your product to Philips implies intent to follow the specified requirements of the warranty and exchange program. [. . . ]