User manual PHILIPS CPWNA001

[. . . ] 1 Antennas For connecting to your Wireless Network (also called WLAN or WiFi). - The indicator LED lights up if there is an active connection. 2 Reset button · Press it for 2 seconds to reboot the wireless base station. · Keep it pressed for more than 5 seconds to restore the factory default settings. [. . . ] If you get the following message, Pinging 192. 168. 2. 1 with 32 bytes of data: Request timed out. there may be something wrong in your installation procedure. Check the following items in sequence: 1. Is the Ethernet cable correctly connected between the Wireless Base Station and the computer?The Local Network LED on the Wireless Base Station and the Link LED of the network card on your computer must be on. Is TCP/IP properly configured on your computer?If the IP address of the Wireless Base Station is 192. 168. 2. 1, the IP address of your PC must be from 192. 168. 2. 2 - 192. 168. 2. 254 and the default gateway must be 192. 168. 2. 1. If you can successfully Ping the Wireless Base Station you are now ready to connect to the Internet! ENGLISH 25 Configuring the Wireless Base Station The Wireless Base Station can be configured by any Java-supported browser including Internet Explorer 5. 0 or above. Using the web management interface, you can configure the Wireless Base Station and view statistics to monitor network activity. Note: Before you attempt to configure your Wireless Base Station, if you have access to the Internet please visit www. philips. com and download the latest firmware update to ensure your Wireless Base Station is running the latest firmware version. Before you attempt to log into the Wireless Base Station's web-based Administration, please verify the following. Enter or clone the MAC address of your modem for identifying your hardware to your ISP. Click Finish to complete the setup. The Status page will open to allow you to view the connection status, as well as other information. See "Status" for details. ENGLISH 29 Fixed-IP xDSL Some xDSL Internet Service Providers may assign a fixed (static) IP address. If you have been provided with this information, choose this option and enter the assigned IP address, gateway IP address, DNS IP addresses, and subnet mask. Click FINISH to complete the setup. PPPoE xDSL Enter the PPPoE User Name and Password assigned by your Service Provider. The Service Name is normally optional, but may be required by some service providers. Leave the Maximum Transmission Unit (MTU) at the default value unless you have a particular reason to change it. Enter a Maximum Idle Time (in minutes) to define a maximum period of time for which the Internet connection is maintained during inactivity. If the connection is inactive for longer than the Maximum Idle Time, it will be dropped. (Default: 10) Enable the Auto-reconnect option to automatically re-establish the connection as soon as you attempt to access the Internet again. Click FINISH to complete the setup. 30 ENGLISH PPTP (Point-to-Point Tunneling Protocol) Point-to-Point Tunneling Protocol is a common connection method used for xDSL connections in Europe. It can be used to join different physical networks using the Internet as an intermediary. [. . . ] Displays the number of attached clients, the firmware versions, the physical MAC address for each media interface, as well as the hardware version and serial number. Displays illegal attempts to access your network. Click on this button to save the security log file. Click on this button to delete the access log. [. . . ]