User manual PHILIPS CSP415

[. . . ] Option 2: Mount on rear tray C You can also mount the speakers into the surface of the rear tray. Follow the steps in section “Option 1: Mount in door” to mount the speakers into the rear tray: Русский 1. Your car stereo speakers Congratulations on your purchase, and welcome to Philips! [. . . ] Product information Note •• Product information is subject to change without prior notice. Introduction With the speakers, you can enjoy high power music with vivid sound. Model Speaker type RMS power (Watts) Sensitivity (dB/W/m) Frequency response (Hz) Impedance (ohms) Magnet mass (Oz) Mounting depth (mm) Model Speaker type RMS power (Watts) Sensitivity (dB/W/m) Frequency response (Hz) Impedance (ohms) Magnet mass (Oz) Mounting depth (mm) CSP415 10cm 2-way coaxial speaker 30W 88dB 50-30kHz 4 ohms 4. E • Cable blanco: conéctelo al terminal (-) • Cable negro (con línea blanca): conéctelo al terminal (+) Nota Notice A depth of at least 46mm is required to mount the speaker. Measure the depth of the area where you are to mount the speaker, and ensure that the speaker does not obstruct any other components of the car. 0 Option 1: Mount on door (front or rear) B You can mount the speakers on the front/rear door of your car. Important Safety • • • • • Read and understand all instructions before you use the apparatus. If damage is caused by failure to follow instructions, the warranty does not apply. Mark the cut-off hole and the 4 bolt holes. B Cut out the marked area and drill the bolt holes. D Strip the speaker wires and connect them to the amplifier. E • Black wire: connect to “-“ (negative) terminal • Black (white lined): connect to “+“ (positive) terminal Note To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the Philips web site (www. When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet. ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. [. . . ] ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. [. . . ]