User manual PHILIPS DC1010

[. . . ] Be sure to observe the following guidelines when using your headphones: Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume as your hearing adapts. Do not turn up the volume so high that you can't hear what's around you. You should use caution or temporarily discontinue use in potentially hazardous situations. [. . . ] · CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. Insert a CD with the printed side facing up and press the CD door gently to close. Display shows -- and later, the total number of tracks. (See 2, 3) Press 2; on the set to start playback. Display: 2 and the current track number. Helpful hints: CD play will also stop when: you open the CD compartment; you select TUNER, AUX, or OFF sound source; the CD has reached the end of playback. Radio reception 1 2 3 · Adjust the source selector to TUNER. Adjust BAND to FM or AM as your desired band. For FM, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For AM, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. To switch off the radio, adjust the source selector to OFF position. 4 5 6 · ­ ­ ­ 4 Selecting a different track · Press or § once or repeatedly until the desired track number appears in the display. · In the stop/pause position, press 2; to start playback. CD Player Finding a passage within a track 1 During playback, press and hold down / §. The CD is played at high speed and low volume. When you recognize the passage you want release / §. Helpful hints: When your searching reaches the end of the last track, the CD goes to stop mode. ­ Helpful hints : If you try to store more than 20 tracks, no track can be selected and the display will show flashing --. To review a program In the stop position, press and hold PROG for two seconds to see your stored track numbers. Erasing a program You can erase the contents of the memory by: ­ in the stop position, press PROG to enter program mode, and then press 9; ­ Selecting TUNER, AUX, or OFF sound source; ­ opening the CD door. Display: PROG disappears. · 2 ­ Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 In the stop position, press PROG to activate programming. [. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. The CD skips tracks ­ · ­ · CD damaged or dirty Replace or clean CD Program is active Quit program mode Display does not function properly/ No reaction to operation of any of the controls ­ Electrostatic discharge · Switch off and unplug the set. Reconnect after a few seconds Severe radio hum or noise ­ Electrical interference: set too close to TV, VCR or computer · Increase the distance Note: A CD badly scratch or dirty may result in improper operation. Environmental information All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. [. . . ]