User manual PHILIPS DCC175

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp. Note:The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] · Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: Do not mix battery types: e. g. Only use batteries of the same type for the set. When inserting new batteries, do not try to mix old batteries with the new ones. Remove the batteries if the set is not to be used for a long time. Using AC Mains Check if the power/mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 1 2 · · · 1 2 3 4 · Connect the power cord to the AC MAINS inlet and the wall socket. The mains lead is now connected and ready for use. To switch the set off completely, withdraw the power cord from the wall socket. Install the unit near the AC outlet and where the AC power plug can be easily reached. Disconnect the mains lead from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit. TM On the DCC175's display, "iPod" is displayed when iPod is connected. 4 The connected iPod player will play automatically. Notes: ­ By using the buttons ( 2;, ¡1, 2 TM and VOLUME ) on the DCC175, the following playback features are available: Play/Pause, selecting next/previous track, and changing volume. ­ The buttons ( 2;, ¡1, 2 TM and VOLUME ) on the DCC175 can work only with playback of the audio contents stored on the docked player. ­ To navigate the iPod menu, you may use iPod MENU, ¡1 / 2TM and 2; buttons on the set. ­ For iPod operations and features, refer to the user manual of your iPod player. ­ This set does not support iPod video output. Charging iPod battery with the dock · In iPod/Tuner/Veille/AUX mode, directly dock your iPod portable player on the cradle for charging. Using a USB mass storage device · By connecting a USB mass storage device to the system, you can enjoy the device's stored music through the system's powerful speakers. Compatible USB mass storage devices: You can use ­ USB flash memory (USB 2. 0 or USB 1. 1) ­ USB flash player (USB 2. 0 or USB 1. 1) Notes: In some USB flash players (or memory devices), the stored contents are recorded using copyright protection technology. Such protected contents will be unplayable on any other devices (such as DCC175 device). Compatibility of the USB connection on this system: a) This product supports most USB Mass storage devices (MSD) that are compliant to the USB MSD standards. [. . . ] 2 Press SOURCE repeatedly to select the USB mode. 3 Plug a compatible USB mass storage device to DCC175's USB port marked . If needed, use a suitable USB cable to connect between the device and DCC175's USB port. TM The device will automatically power on. [. . . ]