User manual PHILIPS DCM2060

[. . . ] Register your product and get support at www. philips. com/welcome DCM2060 EN User manual Contents 1 Important Know these safety symbols Hearing Safety 4 4 5 8 9 Troubleshooting Notice 19 20 2 Your Micro System Introduction What's in the box Overview of the main unit Overview of the remote control 6 6 6 7 8 3 Get started Placement Connect FM antenna Prepare the remote control Connect power Store FM radio stations automatically Set clock Turn on 9 9 9 10 10 10 11 11 4 Play Play disc Play from USB Play from iPod/iPhone/iPad Play options Adjust sound Display different information 12 12 12 12 13 14 14 5 Listen to FM radio Tune to FM radio stations Program FM radio stations automatically Program FM radio stations manually Select a preset radio station Show RDS information Select stereo/mono broadcast 15 15 15 15 15 15 16 6 Other features Set the alarm timer Set the sleep timer Play from external audio device Listen through the headphone 16 16 17 17 17 7 Product information 6SHFLÀFDWLRQV USB playability information Supported MP3 disc formats 18 18 19 EN 3 English 1 Important Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or RWKHU DSSDUDWXV LQFOXGLQJ DPSOLÀHUV WKDW produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the unit. [. . . ] » The unit automatically stores FM radio VWDWLRQV ZLWK VXIÀFLHQW VLJQDO VWUHQJWK DQG WKHQ EURDGFDVWV WKH ÀUVW SUHVHW station. Tip Turn on Press . » The unit switches to the last selected source. Note To select a source, press SOURCE repeatedly or the source selection buttons on the remote control. English To exit storing mode, press or . Set clock 1 In standby mode, press and hold CLOCK SET on the remote control for two seconds. » [SET CLOCK] VHW FORFN VFUROOV RQ the display. repeatedly to select hour Switch to standby mode Press again to switch the unit to standby mode. » 7KH FORFN LI VHW DSSHDUV RQ WKH GLVSOD\ panel. 2 3 4 5 6 7 Press CLOCK SET WR FRQÀUP » The hour digits blink. Repeat steps 3-4 to select whether to synchronize time of this unit with RDS stations. [RDS TIME SYNC [N] ]: time synchronization is deactivated. [RDS TIME SYNC [Y] ]: the unit synchronizes time from the RDS stations automatically. Note The accuracy of the transmitted time depends on the RDS station that transmits the time signal. If no button is pressed in 90 seconds, the unit exits clock setting mode automatically. EN 11 4 Play Play disc 1 2 3 4 Press Press to open the disc compartment. Insert a disc with the printed side facing up. Press CD on the remote control to select the disc source. » [Reading] UHDGLQJ EOLQNV IRU D moment, then CD starts playing automatically. If not, press . Play from iPod/iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this unit. Compatible iPod/iPhone/iPad The unit supports the following iPod, iPhone and iPad models: Made for. iPod touch (1st, 2nd, 3rd, and 4th JHQHUDWLRQ iPod nano (2nd, 3rd, 4th, 5th, and 6th JHQHUDWLRQ iPhone 4 iPhone 3GS iPhone 3G iPhone iPad 2 iPad Play from USB Note Make sure that the USB device contains playable audio content. Load the iPod/iPhone 1 1 Insert the USB device into the socket. Push DOCK for iPod/iPhone/iPad to open the dock compartment. Place the iPod/iPhone into the dock. 2 2 Press USB on the remote control to select the USB source. If not, press . Load the iPad For iPad or iPad 2, you can use the supplied rubber pad to keep it stable. 12 EN 1 2 3 Place the rubber pad into the dock compartment as indicated. To erase the program, when playback is stopped, press . Adjust sound During play, you can adjust volume and select sound effects. Function To increase/decrease volume To mute/restore sound To turn dynamic bass enhancement on/off To select a sound effect: [POP@ SRS [JAZZ@ MD]] [CLASSIC@ FODVVLF [ROCK@ URFN [FLAT@ ÁDW Action Press VOL +/-. Press DSC repeatedly. 14 EN Tune to FM radio stations Note Position the antenna as far as possible from TV, VCR, or other radiation source. 1 2 3 4 5 In tuner mode, tune to an FM radio station. Press PROG to activate programming mode. » [PROG] SURJUDP EOLQNV Press / number. repeatedly to select a channel Ensure that you have connected and fully extended the supplied FM antenna. Press PROG DJDLQ WR FRQÀUP Repeat steps 1-4 to store other FM stations. Note 1 2 Press FM to select FM tuner mode. » [SEARCH] VHDUFK LV GLVSOD\HG » The unit tunes to an FM station with strong reception automatically. To remove a pre-stored station, store another station in its place. 3 Repeat step 2 to tune to more stations. [. . . ] Remote control does not work %HIRUH \RX SUHVV DQ\ IXQFWLRQ EXWWRQ ÀUVW select the correct source with the remote control instead of the main unit. Reduce the distance between the remote control and the unit. Insert the battery with its polarities (+/­ VLJQV DOLJQHG DV LQGLFDWHG EN 19 Supported MP3 disc formats ISO9660, Joliet Maximum title number: 999 (depending on ÀOH QDPH OHQJWK Maximum album number: 99 6XSSRUWHG VDPSOLQJ IUHTXHQFLHV N+] 44. 1 kHz, 48 kHz 6XSSRUWHG %LWUDWHV a NESV variable bit rates Replace the battery. Aim the remote control directly at the sensor on the front of the unit. 9 Notice $Q\ FKDQJHV RU PRGLÀFDWLRQV PDGH WR WKLV device that are not expressly approved by Philips Consumer Lifestyle may void the user's DXWKRULW\ WR RSHUDWH WKH HTXLSPHQW No disc detected Insert a disc. [. . . ]