User manual PHILIPS DECT BABY MONITOR SCD590

[. . . ] This Philips baby monitor provides round-the-clock support by ensuring you can always hear your baby clearly without any distracting noise. The DECT technology guarantees zero interference from other wireless appliances and a clear signal between the parent unit and baby unit. The baby monitor allows you to hear your baby at a distance of up to 300 metres/900 feet in open air. It is not a substitute for responsible and proper adult Supervision and should not be used as such. [. . . ] It takes about 30 seconds before a connection is established. , When a connection has been established between the parent unit and the baby unit, the connection lights on both units burn green continuously. 1) , If no connection has been established after 0 seconds, both connection lights burn red and the parent unit beeps from time to time. , Place the baby unit at least 1 metre/ feet away from your baby. Make sure it is at least 1 metre/ feet away from the baby unit. Depending on the surroundings and other disturbing factors, this range may be smaller. Features Extra parent unit This appliance comes with two parent units instead of one, so that your baby can be monitored by two persons at the same time. Adjusting loudspeaker volume 1 Briefly press the volume + and ­ buttons on the baby unit until the desired loudspeaker volume for the baby unit has been reached. 16) Briefly press the volume + and ­ buttons on the parent unit until the desired loudspeaker volume for the parent unit has been reached. 1) Note:If you press the volume + and ­ buttons too long, the volume will not be adjusted. Note:If the volume is set to a high level, the units consume more power. Talk function You can use the talk button on the parent unit to talk to your baby (e. 1 Press and hold the talk button and talk clearly into the microphone. Release the talk button when you have finished talking. Note:When you press the talk button, you can no longer hear your baby. Microphone sensitivity With the sensitivity button on the parent unit you can set the sound that is picked up by the baby unit to the desired level. When the microphone sensitivity is at maximum level, the baby unit picks up all sounds (including your baby's breathing, when loud enough). You can only change the microphone sensitivity if the connection between the baby unit and the parent unit has been established. Turn the belt clip to the left () until it locks into position (`click'). Disconnecting the belt clip , , , Turn the belt clip to the right (in the direction of TM) (1) and take it out of the opening (). ) Connecting the neck strap Insert the small pin at the end of the neck strap into the opening on the back of the parent unit (1). Turn the neck strap to the left () until it locks into position (`click'). [. . . ] the specified operating range of the baby monitor is 300 metres/900 feet. Why does my baby monitor manage a much smaller distance than that?Why is the connection lost every now and then?The parent unit may be switched on during charging. [. . . ]