User manual PHILIPS DS 1155

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. [. . . ] ___________________________ Adjust time 1 2 3 4 In standby mode, press and hold CLOCK to enter the clock setting mode. »» [24H] or [12H] hour format is displayed. Press +/- to select [24H] or [12H] hour format, and then press CLOCK. »» The hour digits are displayed and begin to blink. Press +/- to set hour, and then press CLOCK. »» The minute digits are displayed and begin to blink. Repeat step 3 to set minute. Connect power Caution supply voltage corresponds to the voltage printed on the back of the unit. When you unplug the AC adaptor, always pull the plug from the socket. •• Before connecting the AC adaptor, make sure that you have completed all other connections. •• Risk of product damage!Make sure that the power Turn on In standby mode, the docking speaker turns on automatically when it detects an audio signal from docked iPod/iPhone. Switch to standby mode The unit switches to standby mode if there is no audio signal from docked iPod/iPhone over 15 minutes. 4 EN 4 Play Play from iPod/iPhone You can enjoy audio from iPod/iPhone through this docking speaker. Listen to the iPod/iPhone Note •• Make sure that the iPod/iPhone is loaded correctly. Start to play music from your iPod/iPhone. »» Music streams from the docking speaker automatically. Compatible iPod/iPhone The docking speaker supports the following iPod/iPhone models. Made for: • iPhone 5 • iPod nano (7th generation) • iPod touch (5th generation) Charge the iPod/iPhone The docked iPod/iPhone begins to charge automatically after connected to power. Charge your mobile phone You can charge your mobile phone through the USB socket in this device with a USB cable (not supplied) Load the iPod/iPhone Insert your iPod/iPhone into the dock. »» The docking speaker synchronizes time from the docked iPod/iPhone. To remove the iPod/iPhone: • Pull your iPod/iPhone out of the dock. EN 5 Adjust volume During play, press +/- repeatedly to increase or decrease the volume. Adjust brightness • • Press CLOCK repeatedly to select different levels of display brightness. Press repeatedly to select different levels of bottom light brightness. 6 EN 5 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power Signal to Noise Ratio 2 x 3W RMS 77 dBA General information AC power adaptor Model: S018KB0590240 (Philips) Input: 100-240 V, 50/60 Hz, 500 mA; Output: 5. 9 V 2400 mA; 18 W ≤500 mA 177 x 177 x 100 mm 0. 88 kg Operation Power Consumption Charging (USB) Dimensions: Main Unit (W x H x D) Weight: Main Unit EN 7 6 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. [. . . ] Please observe the “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. [. . . ]