User manual PHILIPS DS8800W

[. . . ] Register your product and get support at www. philips. com/welcome DS8800W/10 EN User manual Contents 1 Important Safety Notice 4 4 5 7 2 Your Entertainment System Introduction What's in the box What else you need Overview of the main unit Overview of the remote control 7 7 7 7 8 9 3 Prepare Connect 9 11 4 Set up a Wi-Fi network for AirPlay Connect the unit to a Wi-Fi network (router) 11 Connect an AirPlay device to the same Wi-Fi network 16 5 Play Stream audio from your AirPlay device Control play Advanced sound settings 8SGDWH ÀUPZDUH 17 17 18 18 18 20 6 Other features Play from an external device (optional) Charge your iPod/iPhone/iPad 20 20 21 7 Product information 6SHFLÀFDWLRQV 21 22 8 Troubleshooting EN 3 English 1 Important Safety Information for Europe: Know these safety symbols i Do not expose the product to dripping / splashing water, rain or high humidity. j Keep this product away from direct VXQOLJKW QDNHG ÁDPHV RU KHDW k Do not install near any heat sources such as radiators, heat registers, stoves, or other electrical equipment (including DPSOLÀHUV l Do not place any other electrical equipment on the product. m Do not place any sources of danger on the product (e. g. objects containing OLTXLGV EXUQLQJ FDQGOHV n This product may include batteries. [. . . ] To switch the unit on from the standby mode, press again. Prepare the remote control Caution 1 Insert the plug from the AC adaptor to the DC IN socket on the back of the main unit. Risk of explosion!Keep batteries away from heat, VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH Perchlorate Material - special handling may apply. See ZZZGWVFFDJRYKD]DUGRXVZDVWHSHUFKORUDWH )RU ÀUVWWLPH XVH Remove the protective tab to activate the remote control battery. To replace the remote control battery: 1 1 2 Open the battery compartment. Insert one CR2025 battery with correct polarity (+/-) as indicated. 2 Connect one end of the AC power cord to the AC adaptor. 3 Connect the other end of the AC power cord to the wall outlet. » It takes about 35 seconds for the main unit to boot up. During boot-up, the indicator on the front of the main unit blinks in green quickly. EN 9 3 Close the battery compartment. Note Before pressing any function button on the remote FRQWURO ÀUVW VHOHFW WKH FRUUHFW VRXUFH ZLWK WKH UHPRWH control instead of the main unit. If you are not going to use the remote control for a long time, remove the battery. 10 EN 4 Set up a WiFi network for AirPlay Note Some operations may vary as you use different types of wireless routers. Select a scenario below that matches your router type. Note Each time when the unit is powered on again, the XQLW HQWHUV WKH ODWHVW FRQÀJXUHG :L)L QHWZRUN automatically. In case of setup failure, repeat the steps, or press and hold on the front of the main unit and try again. The unit is compatible with the following iPod/ iPhone/iPad models: iPod touch (2nd, 3rd, and 4th generation) iPhone 4 iPhone 3GS iPad 2 iPad Scenario 1: Connect to a WPS-PBC router 1 Press WI-FI SETUP on the back of the main unit. » The indicator blinks in red, green, and yellow alternately. WIFI WI-FI SETUP SETUP 2 Before setup of the Wi-Fi network, check the points below. Press the WPS button on the wireless router. » After a while, the indicator stops blinking and stays green, and the speaker beeps. » The unit joins the Wi-Fi network successfully. 1 2 3 Make sure that the wireless router is powered on and working properly. Make sure that the indicator on the front of the main unit blinks in green slowly. Check the type of the wireless router you use. EN 11 English Connect the unit to a Wi-Fi QHWZRUN URXWHU WPS 3 Select Settings -> Wi-Fi on your iPod touch/iPhone/iPad. Or enter the list of available wireless networks on your PC/Mac. Tip To change the name of the unit for AirPlay, proceed with steps in `Scenario 2: Connect to a non-WPS router' below. For some wireless routers, you may need to hold the WPS button for WPS connection. See the user manuals RI WKH VSHFLÀF URXWHUV IRU GHWDLOV Scenario 2: Connect to a non-WPS router You can connect the unit to a non-WPS router through an iOS 4. 2 (or later) enabled iPod touch/iPhone/iPad a Wi-Fi enabled PC or Mac installed with iTunes 10 (or later) 4 Select Philips Fidelio AirPlay from the list of available networks. Connect DS8800W to your iPod touch/iPhone/iPad or PC/Mac Philips Fidelio AirPlay 1 Press and hold WI-FI SETUP on the back of the main unit for more than 5 seconds. » The indicator blinks in green and yellow alternately. Tap on the AirPlay icon. 4 6HOHFW D PHGLD ÀOH DQG VWDUW SOD\ 5 Wait until successful audio streaming to the speakers. EN 17 English Select Philips_Fidelio XXXX (or user FXVWRPL]HG QDPH IURP WKH OLVW Stream from your Wi-Fi enabled PC or Mac installed with iTunes 10 (or ODWHU Note Before you open iTunes, make sure that you have enabled Bonjour service in your PC. Take Windows XP for example: to enable the service, you can click Start->Settings->Control Panel, and double-click Administrative Tools-> Services->Bonjour Service, and then click Start followed by OK on the pop-up menu. Advanced sound settings For advanced sound settings and additional features, you can use your AirPlay device to download the Philips Fidelio application from Apple App Store. 8SGDWH ÀUPZDUH Note <RX FDQ RQO\ XSGDWH WKH ÀUPZDUH IURP D 3&0DF 1 2 3 4 5 Open iTunes 10 (or later). Click the AirPlay icon at the bottom right corner of the window. Select Philips_Fidelio_AirPlay XXXX (or XVHU FXVWRPL]HG QDPH IURP WKH OLVW 6HOHFW D PHGLD ÀOH DQG VWDUW SOD\ Wait until successful audio streaming to the speaker. 'RZQORDG WKH XSGDWH ÀOH 1 2 3 On your PC/Mac, go to www. philips. com/ support. [. . . ] Keep away from potential sources of interference which may affect Wi-Fi signal, such as microwave ovens. If you fail to use your PC for Wi-Fi network setup, check whether your PC is using a Wi-Fi network. You cannot use Ethernet connection for AirPlay network setup. If the problem remains, it is strongly recommended to use iPod Touch/iPhone/ L3DG0DF WR GR WKH ÀUVWWLPH :L)L VHWXS as some PC settings may affect the Wi-Fi network setup. [. . . ]