User manual PHILIPS DTX6372-05A

[. . . ] . 1 PRODUCTS COVERED BY THIS USER MANUAL . . 5 4 CONNECTING TO YOUR EXISTING EQUIPMENT . . 7 4. 1 4. 2 4. 3 4. 4 If your television set and video have SCART sockets . 7 If your television set and video have ONLY a standard coaxial aerial input . [. . . ] (Press MENU, then buttons 3 and 2 in turn). Enter your current code where requested. With the channel list displayed press the GREEN button as indicated on-screen, this will open all the padlocks. Pressing this button again will close the padlocks. The top of the screen will indicate whether the locks are open or close. IMPORTANT: Don't forget to your channels again after unlocking them all in this manner. 9. 4 RE-ARRANGING YOUR CHANNELS This feature enables you to swap two channel positions within the total channel list, so that they are displayed in your prefered order. Press the MENU button then button 5 and 2 to get access to change channel number menu. A complete list of channels currently available on your digital receiver is displayed. (Alongside these channels will be symbols to indicate whether they have been selected as your favourite or locked channels). To move a channel to an alternative location, firstly highlight the channel using the UP and DOWN arrow buttons and press the SELECT button to choose that channel. Now select the new channel location using the UP and DOWN arrow buttons to highlight the channel number where you want to move the channel to. The original channel remains highlighted. Lastly, press the SELECT button to swap the two channel locations. Repeat the above steps to move further channels or press the EXIT button to return to a normal TV picture. Press the B button to store the new order of your channels. 20 9. 5 SETTING THE TIMER The timer settings function enables you to program your digital receiver to switch on and off at selected times, for upto 8 different time slots. Your video can then be set to record digital programmes. At any stage of the following procedure, pressing the RED button on the remote will return you to the previous menu, or pressing the EXIT button will discard any changes that have been made and return your receiver to normal operation. Firstly press the MENU button on the remote, to display the main menu. The setting the timer option will already be highlighted. Select this option by pressing either the SELECT button or a number button 1 on your remote. The screen will now show a list of 8 timer slots, each one indicating that it is either available for programming, or that it has a programme already stored in it. 4. Select an available row using the UP and DOWN buttons, then press the SELECT button to display the setting the timer screen. [. . . ] If you set the timer and have finished watching TV, make sure you put your receiver into standby, otherwise it will not activate. If you set the timer and continued watching, you must change to the timer channel when the alarm activates. Only set the timer for the exact time of the programme. Allow for the 5minutes run in and out times when setting more than one event. [. . . ]