User manual PHILIPS DVD623-001

[. . . ] The region code for Australia is 4. Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic" and the double-D symbol are trademarks of Dolby Laboratories. LASER Type Semiconductor laser GaAlAs Wave length 650 nm (DVD) 780 nm (VCD/CD) Output Power 7 mW (DVD) 10 mW (VCD/CD) Beam divergence 60 degree CAUTION (WARNING LOCATION: ON THE BACKPLATE OF SET) NEVER MAKE OR CHANGE CONNECTIONS WITH THE POWER SWITCHED ON. CAUTION VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM For Customer Use: Read carefully the information located at the rear panel of your DVD VIDEO player and enter below the Serial No. Retain this information for future reference. __________________________ Important Note: Due to the numerous versions of new CDAudio copy protection or enhanced CD-Audio protection recently available on certain discs, Philips is unable to guarantee that this DVD player is fully compatible with such new discs. [. . . ] MONO RIGHT & MONO LEFT options can fade out the original vocal. Karaoke learning and language learning function VCD 1 2 3 4 Press MODE to display karaoke menu. Press 3 again to start recording from the point you perfer. DVD player will record your voice and original karaoke music. DVD player will playback the recording three times in total to let you make a comparasion. Follow the instruction of step4 to step5 to record other sequence. Press 4 to quit Karaoke learning and language learning function. 5 To adjust the volume of microphone, turn the knob LEVEL1 or LEVEL2 on the right of front panel. Press KARAOKE on the remote control to display karaoke menu. karaoke menu appears on TV screen, and the option `MIC' is highlighted. 0 Press 3 4 to switch off karaoke function. NOTE: Please set the option DOWNMIX to LT/RT, VSS or STEREO before switching on Karaoke function. 5 6 7 General setup of karaoke function Press MODE to display karaoke menu (Karaoke menu will disappear if you do not press any key in a minute). Note: Keeping highlight cursor on RECORD option will allow you to record by pressing 3 , and 4 to quit. otherwise pressing 3 or 4 will get slow motion effect. KEY CONTROL 1 2 Press 1 2 to highlight the option KEY. 1 Press the 34 keys to highlight the DISC LOCK item in the GENERAL SETUP menu. 3 Enter the submenu by pressing the 2 key. 4 Press the 1 key to return to the GENERAL SETUP menu. When playback a locked disc, the DVD player will prompt to enter your password or 3308 (default) password. To change the password , refer to the option PASSWORD in the PREFERENCE menu . 1 2 Stop the program playback At the PROGRAM page, when programing is completed, 1 Press the 1 234 keys to move the cursor to the QUIT button. 2 Press the OK key to quit this menu or 0 Press the STOP key twice to exit. VFD Dim 1 2 3 This function is used to adjust the brightness of VFD on the front panel. Press the 34 keys to highlight VFD DIM in the GENERAL SETUP menu. Enter the submenu by pressing the 2 key. 16 DVD616K IFU for /751 3141 016 18911 Setup Menu 4 Move the cursor by pressing the 34 keys to highlight the selected item. 100: make the VFD brighter than normal. 70: standard brightness 40: make the VFD to dim mode. Press the 1 key to return to the GENERAL SETUP menu. [. . . ] If you set a rating for the player, all scenes with the same rating or lower will be played. Higher rated scenes will not be played unless an alternative which has the same rating or lower is available on the disc. If no suitable alternative is found, playback will stop and the 4-digit code has to be entered. In this menu, it contains of the setting when you playback picture CD and MP3 CD. Press the 3 4 key to highlight the PREFERENCE item. [. . . ]