User manual PHILIPS DVD757VR

[. . . ] AAA AAA Digital Video Disc Player & Video Cassette Recorder DVD757VR R 1 General Information The region code for this set is 2. Since it is usual for DVD movies to be released at different times in different regions of the world, all players have region codes and discs can have an optional region code. If you load a disc of a different region code to your player, you will see the region code notice on the screen. The disc will not playback, and should be unloaded. English Introduction wThank you for purchasing this Philips DVD/ VCR. This Owner's Manual explains the basic operation of this DVD/VCR. 2 Environmental Information All unnecessary packaging has been omitted. [. . . ] Select 'RECORD LINK' with K/L. SELECT K L CHOOSE B Select function 'ON' with B. RECORD SPEED [SP] To end, press STATUS/EXIT. DIRECT RECORD [OFF] ¡ RECORD LINK [OFF] Insert a cassette. Programme the satellite receiver with the required information (programme number of the TV channel, END=EXIT start time, end time). If necessary, please see the operating instructions for your satellite receiver. The DVD/VCR is now ready to record. The beginning and end of the recording is controlled via scart socket AV2(DECODER). 2 3 4 5 6 7 1 2 3 4 5 6 7 8 9 Recording(From DVD To VCR) 1 Insert a DVD without copyright protection in the tray. 2 Insert a video cassette tape with its erase prevention tab in place. Details are at "Selecting the recording speed (SP or LP)". 4 Enter "004" with numerical key pads to appear "DISC" on the TV screen. 7 Press DVD, then PLAY B to begin the playback of a DVD. 8 Press VCR, then STOP C to stop recording. 10 11 English Programming a Recording (TIMER) General information Use a TIMER programming to automatically start and stop a recording at a later time or date. The DVD/VCR will switch to the right programme number and begin recording at the correct time. With this DVD/VCR, you can pre-programme up to eight recordings within a period of one year. To make a programmed recording, your DVD/VCR needs to know: * the date you want to make the recording * the programme number of the TV channel * the start and stop time of the recording * VPS or PDC on or off This information is saved in a TIMER block. 'VPS' (Video Programming System)/ 'PDC' (Programme Delivery Control) are used to control the start and duration of TV channel recordings. If a TV programme starts earlier or ends later than scheduled, the DVD/VCR will turn on and off at the correct time. What do I need to know about 'VPS/PDC'?Usually the VPS or PDC time is the same than the start time. But if your TV guide shows a VPS or PDC time which is different from the programme's scheduled start time, e. g. 20. 10 (VPS/PDC 20. 14), you must enter the VPS/PDC time exact to the minute. If you want a start time different from the VPS/PDC time, you must switch VPS/PDC off. 5 The decoded data appears after confirmation. You can go back to change the data. Select the corresponding input field using B or CLEAR. 6 When all inputs are correct, press STATUS/EXIT. The programming information is stored in a Timer block. [. . . ] Aim the remote control directly at the sensor on the front of the DVD/VCR. Replace the batteries in the remote control. Re-insert the batteries with their polarities (+/­ signs) as indicated. To completely reset the DVD/VCR, unplug the AC cord from the AC outlet for 5-10 seconds. [. . . ]