User manual PHILIPS FC6052

[. . . ] Never immerse the vacuum cleaner or the charging unit in water and do not let water enter the motor unit or the charging unit. Remove the adapter from the wall socket before cleaning the charging unit. Only charge the vacuum cleaner with the adapter and charging unit supplied. During charging, the adapter will feel warm to the touch. [. . . ] 1 Insert the adapter into the wall socket. The charging light will stay on as long as the appliance is connected to the charging unit and the adapter is in the wall socket. The charging light does not give any information about the charge level of the built-in batteries. 3 Leave the adapter in the wall socket and always put the vacuum cleaner back onto the charging unit immediately after use, even if the batteries are still almost fully charged. Brush, crevice tool and squeegee This appliance comes with three accessories: - a brush tool to clean delicate surfaces; - a crevice tool to clean hard-to-reach places; - a squeegee to suck up liquids. 1 Take the accessory you want to use from the charging unit. When sucking up liquids, hold the appliance with the nozzle pointing downwards at an angle of 30c. Stop sucking up liquids when the liquid level inside the dust compartment has reached the maximum indication line. Never hold the appliance with the on/off slide pointing downwards when the dust compartment is filled with liquid (fig. Empty the dust compartment each time you have used the appliance to suck up a liquid. 3 You can store all accessories by placing them in the storage slots in the charging unit (fig. Cleaning Always remove the adapter from the wall socket before cleaning the charging unit. When you have used the appliance to suck up liquids, empty and dry the dust compartment. 1 Clean the appliance with a damp cloth. Emptying the dust compartment Make sure you empty the dust compartment and clean the filter regularly. Remove the filter from the filter holder by turning it anticlockwise. B Clean the filter with a brush or with a normal vacuum cleaner if it is very dirty. B If necessary, you can rinse the filter in cold or lukewarm water. 5 Fasten the filter in the filter holder by turning it clockwise and put the filter holder into the dust compartment. Make sure you insert the filter holder in the correct way (fig. [. . . ] Only remove the batteries if they are completely empty. remove the batteries in the following way. 1 Let the appliance run until it stops, undo the screws and open the vacuum cleaner (fig. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. [. . . ]