User manual PHILIPS FC6120

[. . . ] Insert the small plug into the socket on the sweeper base (Fig. , The charging light is on continuously during charging and after the battery is fully charged. The charging light goes out when you disconnect the appliance from the mains. Using the appliance 1 To unlock the stick from its storage position, put your foot on top of the sweeper base to prevent it from tilting. [. . . ] 5 Place the dirt tray back into the sweeper base and push it down into position. 1 Switch off the appliance before you clean the roller brush. 2 Remove the transparent front cover from the sweeper base. Grab the bottom edge of the cover with both hands, pull it outwards (1) and upwards (2) firmly until it is released from the slots (Fig. Rotate the roller brush until the cutting groove faces you. Use a pair of scissors to cut the hairs, threads etc that have collected around the roller brush (Fig. Remove fluff, hairs and other dirt from the roller brush. Removing the roller brush 1 To remove the stick, press the button on the lower handle (1) and pull the stick upwards (2) (Fig. 2 Turn the sweeper base upside down, push the release slide in the direction of the arrow (1) and remove the retainer (2) (Fig. Slip the belt off the end of the roller brush (1) and lift the brush out of the base (2) (Fig. Remove fluff, hairs and other dirt from the roller brush and the groove. reinserting the roller brush 1 Slip the belt over the ribbed end of the roller brush. Insert the other end of the roller brush into the slot opposite the belt (Fig. 2 Insert the end of the roller brush with the belt into the other slot. 19) Do not force the roller brush into the slot. rotate the roller brush so that the ridge on the side with the belt points upwards. Put the retainer back into the slot (1) and slide the release slide to the original position (`click') (2) (Fig. Grab the cover with both hands, push it downwards (1) and inwards (2) firmly until it snaps back into the slots (`click'). 2 Remove the transparent front cover from the sweeper base. Grab the bottom edge of the cover with both hands, pull it outwards (1) and upwards (2) firmly until it is released from the slots (Fig. [. . . ] Then park the appliance against a wall (Fig. To hang the appliance from the wall, tilt the side of the sweeper base with the roller brush towards the stick (`click'). Then hang the appliance on a nail by the hanging slot in the back of the upper handle (Fig. 1 Remove the battery pack when you discard the appliance. [. . . ]