User manual PHILIPS FC6126

[. . . ] Never pick up water, liquids or wet food substances. Never pick up flammable substances and do not pick up ashes until they are cold. Do not stick your hands/fingers into the rotating roller brush to avoid injuries. Do not move the appliance over a mains cord as this may cause a hazard. [. . . ] Clean the appliance and its parts with a damp cloth. Press the dirt tray release button (1) and lift the dirt tray out of the sweeper base (2) (Fig. Then press the slide on the lower handle downwards to open the dirt tray door and empty the dirt tray (Fig. 5 Place the dirt tray back into the sweeper base and push it down into position (Fig. The dirt tray door closes automatically when you put the dirt tray back into the sweeper base (`click'). Cleaning the roller brush 1 Switch off the appliance before you clean the roller brush. Rotate the roller brush until the cutting groove faces you. Use a pair of scissors to cut the hairs, threads etc. Remove fluff, hairs and other dirt from the roller brush. Note: If you are unable to clean the roller brush properly in this way, you can remove it for more thorough cleaning. see sections `Removing the roller brush' and `Reinserting the roller brush' below. Removing the roller brush 1 To remove the stick, press the stick release button on the lower handle (1) and pull the stick upwards (2) (Fig. Turn the sweeper base upside down, push the retainer release slide in the direction of the arrow (1) and remove the retainer (2) (Fig. Slip the belt off the end of the roller brush (1) and lift the roller brush out of the base (2) (Fig. Remove fluff, hairs and other dirt from the roller brush and the groove. reinserting the roller brush 1 Slip the belt over the ribbed end of the roller brush. Insert the other end of the roller brush into the slot opposite the belt (Fig. Insert the end of the roller brush with the belt into the other slot. 19) Do not force the roller brush into the slot. rotate the roller brush so that the ridge on the side with the belt points upwards. Put the retainer back into the slot (1) and slide the release slide to its original position (`click') (2) (Fig. If the roller brush is not properly inserted, you cannot move the release slide to locked position. [. . . ] Solution Insert the adapter properly into the wall socket. Insert the small plug properly into the appliance. Make sure the on/off switch is in off position. Make sure you place the dirt tray properly in the sweeper base after you have emptied it (see chapter `Cleaning'). [. . . ]