User manual PHILIPS FC 6130

[. . . ] If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Caution Remove the plug from the wall socket before you clean the appliance. Always switch off the appliance after use. Never block the exhaust air openings during vacuuming. [. . . ] Cleaning Never immerse the appliance in water or any other liquid, nor rinse it under the tap. 1 Remove the plug from the wall socket before you clean the appliance. 2 Clean the appliance with a damp cloth. Emptying the dust compartment quickly Make sure you empty the dust compartment regularly to optimise the performance of the appliance. Always unplug the appliance before you empty the dust compartment. 1 Press the nosepiece release button (1) and remove the nosepiece from the appliance (2) (Fig. Tip: Alternatively, you can use a normal vacuum cleaner to suck the contents out of the dust compartment. 14) Cleaning the dust compartment thoroughly 1 Press the dust compartment release button (1) and remove the dust compartment from the appliance (2) (Fig. 5 If necessary, clean the dust compartment with a damp cloth. First attach the bottom of the dust compartment. Then push the top of the dust compartment towards the appliance until it locks into place (`click') (Fig. Cleaning the filter unit 1 Press the dust compartment release button (1) and remove the dust compartment from the appliance (2) (Fig. 3 To detach the outer filter from the inner filter, turn the filter outer filter anticlockwise (1) and pull it off the inner filter (2) (Fig. If the filters are very dirty, clean them with a normal vacuum cleaner (Fig. 5 Put the outer filter back onto the inner filter (1) and turn the outer filter clockwise to lock it (2) (Fig. First attach the bottom of the dust compartment. Then push the top of the dust compartment towards the appliance until it locks into place (`click') (Fig. Storage 1 Wind the cord round the body of the appliance (Fig. Upright storage (FC6132 only) 1 You can store the appliance in upright position with the floor nozzle and stick attached on a flat hard floor (Fig. 2 Put the floor nozzle in the position in which the ridges are aligned with each other. If you store the appliance this way, do not store it near fragile valuables. The appliance is equipped with the special Clean Air HEPA filter. [. . . ] Work properly when the floor nozzle (FC6132), the hose (FC6130), the brush tool or the crevice tool is attached. If it is clogged, remove the filter unit and clean the inner and outer filter (see chapter `Cleaning'). i cannot store the appliance upright (FC6132). Make sure that the floor nozzle is attached. [. . . ]