User manual PHILIPS FC8210

[. . . ] 2 To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance. Tube Conical coupling (specific types only) 1 To connect the tube to the handgrip, insert the narrow section into the wider section while turning it a little (fig. Use the same methods to connect the accessories to or to disconnect them from the tube or handgrip. 2 To disconnect the tube from the handgrip, push the lock button and pull the tube out of the handgrip (fig. [. . . ] Use the same methods to connect the accessories to or to disconnect them from the tube or handgrip. Telescopic tube (specific types only) 1 Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. Nozzle Convertible nozzle (specific types only) The convertible nozzle can be used on either carpets or hard floors. 2 Push the rocker switch on top of the convertible nozzle with your foot to make the brush strip for cleaning hard floors come out of the nozzle housing (fig. 3 Push the rocker switch again to make the brush strip disappear into the convertible nozzle housing (fig. Reach & Clean nozzle (specific types only) The Reach & Clean nozzle can be used on either carpets or hard floors. The nozzle can be turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach places in an easy way. When the nozzle is positioned lengthwise, the suction power is concentrated at the front side of the nozzle (fig. To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the indicated spot and then turn the tube until the nozzle is in the required position (fig. 2 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large hard floor areas. Storage 1 Switch the appliance off and remove the mains plug from the wall socket. Replacing the dustbag Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i. Even when the nozzle is not placed on the floor (fig. 1 Switch the appliance off and open the cover (fig. 3 Remove the full dustbag from the holder by pulling it up by the cardboard tag, which will cause the dustbag to be sealed (fig. 4 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder. You cannot close the cover if no dustbag has been inserted. Ordering dustbags Philips Classic s-bag` paper dustbags are available under type number FC8021. 2 Insert a new filter into the holder with the white side pointing towards the dustbag compartment (fig. 2 Remove the old filter and place the sides and the bottom edge of the new filter properly behind the ridges of the holder on the inside of the grille. [. . . ] 2 Remove the old filter and place the sides and the bottom edge of the new filter properly behind the ridges of the holder on the inside of the grille. 3 Put the grille back into the vacuum cleaner by first hooking the bottom edge of the grille into the appliance (1) and then pushing the grille towards the appliance (2) until it snaps home (fig. Super Clean Air HEPA Filter (specific types only) Instead of the Super Clean Air Filter, some types are equipped with the special Super Clean Air HEPA Filter. This filter not only removes household dust, but also harmful microscopic vermin. [. . . ]