User manual PHILIPS FC8388

[. . . ] When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become clogged, causing the passage of air through the dustbag to become obstructed. As a result, the 'dustbag full' indicator will indicate that the dustbag needs to be replaced, even though the dustbag is not full at all. [. . . ] 5 The crevice nozzle can be found in the special storage compartment (fig. 6 To carry the appliance, put the handle in upright position (fig. 7 You can adjust the suction power by means of the slide on the handgrip (specific types only) (fig. 8 You can adjust the suction power by means of the electronic suction power control (specific types only) (fig. Storage 1 Put the appliance in upright position and attach the lower tube to the appliance by means of the clip (fig. The clip can be slide along the tube to adjust its height. Replacing the dustbag Replace the dustbag as soon as the 'dustbag full' indicator has changed colour permanently. 1 Switch the appliance off and open the cover (fig. 3 Lift the dustbag out of the compartment by pulling the cardboard lug upwards, which causes the dustbag to be sealed (fig. 4 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder. You cannot close the cover if no dustbag has been inserted (fig. Philips s-bagTM paper dustbags are available under type number FC8021 (883802101010). [. . . ] Com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. [. . . ]