User manual PHILIPS FC8802/01

[. . . ] FC8802 FC8800 User manual 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 English 6 Dansk 16 Deutsch 26 Español 39 Suomi 50 Français 60 Italiano 71 Nederlands 82 Norsk 93 Português 104 Svenska 115 FC8802, FC8800 6 English Important Read this user manual carefully before you use the robot and save it for future reference. Read all the warnings and safety issues below before you use the robot. Danger -- Do not immerse the robot or the adapter in water or any other liquid. -- Do not use the robot on wet floors or in places where there is a risk of contact with water or immersion in water. [. . . ] Caution: Avoid using the robot near a staircase or other height difference or monitor it carefully. Depending on specific circumstances in your home, the drop-off sensors in the bottom may not detect a staircase or height difference in time. , , The battery indicator lights up continuously during cleaning (Fig. 2 The robot cleans the floors until the rechargeable battery is low or until it is switched off manually. note:The robot follows predefined cleaning patterns. See chapter ‘How your robot works’, section ‘How your robot cleans’ for more details. Note: If the battery runs low during cleaning, the battery indicator flashes quickly and you hear two beeps. Recharge the robot to continue cleaning (see chapter ‘Preparing for use’, section ‘Charging’) (Fig. English 11 Indicator signals and their meaning The robot has a display with three indicators: the battery indicator, the dust compartment indicator and the warning indicator. The table below explains the meaning of the signals these indicators give. The battery indicator flashes quickly and the robot beeps twice every minute. The dust compartment indicator lights up continuously. The warning indicator flashes quickly and the robot beeps twice every minute. The robot was switched on while it was not placed on a level floor or not on the floor at all. Cleaning and maintenance The plug must be removed from the socket-outlet before cleaning or maintaining the appliance. 4 Also use the brush to remove dust or fluff from the front wheel and side wheels. 5 Clean the drop-off sensors with a cotton bud to remove dust and fluff (Fig. Note: It is important that you clean the drop-off sensors regularly. If the drop-off sensors are dirty, the robot may fail to detect height differences. Cleaning the side brushes After some time, fluff, hairs and threads start to accumulate around the shafts of the side brushes. To ensure proper functioning, clean the side brushes and the shafts from time to time. 1 Make sure the on/off switch is in ‘off’ position. [. . . ] This causes the robot to move in an unusual pattern. The robot is cleaning a floor that reflects sunlight quite strongly. This triggers the drop-off sensors and causes the robot to move in an unusual pattern. The battery can no longer be charged or runs empty very fast. [. . . ]