User manual PHILIPS FC8802/03

[. . . ] FC8802 FC8800 User manual 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 English 6 Dansk 16 Deutsch 26 Español 39 Suomi 50 Français 60 Italiano 71 Nederlands 82 Norsk 93 Português 104 Svenska 115 FC8802, FC8800 6 English Important Read this user manual carefully before you use the robot and save it for future reference. Read all the warnings and safety issues below before you use the robot. Danger -- Do not immerse the robot or the adapter in water or any other liquid. -- Do not use the robot on wet floors or in places where there is a risk of contact with water or immersion in water. [. . . ] Using your robot Preparing for cleaning 1 Before you switch on the robot, clear the floor of loose objects such as toys, magazines and shoes. Remove mains cords, wires and the pull cords of curtains or blinds from the floor. 2 Remove the small plug from the socket on the robot if it is still inserted (Fig. Note:The robot does not operate when it is connected to the mains. Therefore, always disconnect the adapter from the robot and the mains before use. Note: Always store the adapter in a safe place before you switch on the robot. 3 Make sure the dust container is empty and the filter is properly installed. 4 Place the robot on the floor in an area where there is enough free space around it. Stay close by when the robot is cleaning near carpets or rugs to see how it is coping. Cleaning 1 Press the on/off switch to switch on the robot (Fig. Caution: Always make sure the filter is present inside the dust container. If you use the robot without the filter inside the dust container, the motor will be damaged. Caution: Avoid using the robot near a staircase or other height difference or monitor it carefully. Depending on specific circumstances in your home, the drop-off sensors in the bottom may not detect a staircase or height difference in time. , , The battery indicator lights up continuously during cleaning (Fig. 2 The robot cleans the floors until the rechargeable battery is low or until it is switched off manually. note:The robot follows predefined cleaning patterns. See chapter ‘How your robot works’, section ‘How your robot cleans’ for more details. Note: If the battery runs low during cleaning, the battery indicator flashes quickly and you hear two beeps. Recharge the robot to continue cleaning (see chapter ‘Preparing for use’, section ‘Charging’) (Fig. English 11 Indicator signals and their meaning The robot has a display with three indicators: the battery indicator, the dust compartment indicator and the warning indicator. The table below explains the meaning of the signals these indicators give. [. . . ] The robot starts to move backwards during cleaning or just after it was switched on. English 15 Problem The warning indicator flashes quickly. The robot was lifted while it was cleaning. The bristles of one or both side brushes are crooked or bent. [. . . ]