User manual PHILIPS FC9114

[. . . ] The Reach & Clean nozzle can be used on either carpets or hard floors. The nozzle can be turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach places in an easy way. When the nozzle is positioned lengthwise, the suction power is concentrated at the front side of the nozzle. 5) To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the indicated spot and then turn the tube until the nozzle is in the required position. [. . . ] While combing your dog or cat with the Animal Brush, dirt, loose hairs and knots will be removed. 15) 2 Place the vacuum cleaner as far away from the dog or cat as possible. set the suction power to the lowest setting. 3 For optimal results, move the brush through the fur of the cat or dog in one direction. 4 You can remove hairs from the Animal Brush by detaching it from the appliance and vacuum cleaning it. You can adjust the suction power while vacuum cleaning. 17) 2 Use maximum suction power for vacuum cleaning very dirty carpets and hard floors. 1 Replace the dustbag as soon as the dustbagfull indicator changes colour. 22) The dustbag is full when the colour of the indicator has changed even when the nozzle is not placed on the floor. Place your fingers at the inlet of the cover and press with your thumb on the ridge on top of the cover. 24) Make sure you hold the dustbag upright when lifting it out of the appliance. 25) When you do this, the dustbag will be automatically sealed. 6 Slide the cardboard tag of the new dustbag into the two grooves of the dustbag holder as far as possible. 26) You cannot close the cover if no dustbag has been inserted. If provided, you can use the cotton dustbag instead of paper dustbags. The cotton dustbag can be used and emptied repeatedly. Replace the Activated Carbon Filter every 6 months or when you notice that smell absorption becomes less effective. 1 To replace the Activated Carbon Filter , see the Motor Protection Filter section above. Instead of cleaning the filter, you have to insert a new filter. The AFS Micro Filter located in the back of this appliance will filter a large part of the smallest particles from the exhaust air by means of its electrostatically charged fibres. 1 Replace the AFS Micro Filter every six months 2 Open the filter grille. 30) 4 Insert the new filter into the appliance. [. . . ] Com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required. The suction power is insufficient: 1 Check if the suction power control is in the required position (see the section on vacuum cleaning - adjusting suction power). [. . . ]