User manual PHILIPS FC9153/01

[. . . ] Register your product and get support at www. νικα 24 Español 31 Suomi 37 Français 43 Italiano 49 Nederlands 55 Norsk 61 Português 67 Svenska 73 Türkçe 79 FC9150-FC9159 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Cord rewind button 2 Suction power knob 3 On/off button 4 Dustbag-full indicator 5 Hose connection opening 6 Hose with swivel connector 7 Dust cover release tab 8 Filter holder with motor protection filter 9 Dustbag holder 10 Dustbag 11 Rear wheel 12 Small nozzle 13 Crevice tool 14 Small brush 15 Handgrip with button coupling 16 Accessory holder 17 TriActive nozzle 18 Rocker switch for carpet/hard floor settings 19 Parking/storage ridge 20 Side brush 21 Telescopic tube with button coupling 22 Hinging top handle 23 Filter grille (open) 24 Parking slot 25 Mains plug 26 Ultra Clean Air HEPA 13 filter 27 Front handle 28 Swivel wheel 29 Storage slot 30 Type plate Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] -- Use maximum suction power to vacuum very dirty carpets and hard floors. -- Use minimum suction power to vacuum curtains , table carpets , etc. Suction power knob -- During vacuum cleaning, you can adjust the suction power with the suction power knob on top of the appliance (Fig. €18) Pausing during use 1 If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to park the tube in a convenient position (Fig. Storage 1 Slide the tube parts into each other to reduce the tube to its shortest length. 2 Switch off the appliance and remove the mains plug from the wall socket. 3 Press the cord rewind button to rewind the mains cord (Fig. English 4 To store the appliance in upright position, insert the ridge on the nozzle into the storage slot (Fig. 9 5 Always put the TriActive nozzle in the carpet setting when you store it (brush strip retracted into the nozzle). Also prevent the side brushes from becoming bent (Fig. Replacing the dustbag Always unplug the appliance before you replace the dustbag. Note: In some cases, the dustbag-full indicator can indicate that the dustbag is full, even though it is not. This may occur if the pores of the dustbag are clogged (e. When you have vacuumed ashes, fine sand, lime, cement dust and similar substances) or if something blocks the nozzle, tube and/or hose. If the pores of the dustbag are clogged, you have to replace the dustbag, even if it is not full yet. If the dustbag is not clogged but not full either, something blocks the nozzle, tube and/or hose. In this case, do not replace the dustbag but remove the obstruction. Replacing the dustbag -- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i. Even when the nozzle is not placed on the floor (Fig. 2 Lift the dustbag holder out of the appliance (Fig. Make sure you hold the holder with the dustbag in horizontal position when you lift it out of the appliance. 3 Pull at the cardboard tag to remove the full dustbag from the holder (Fig. [. . . ] -- Ultra Clean Air HEPA 13 Filters are available under type number FC8038. Environment -- Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. Guarantee and service If you need service or information or if you have a problem, please visit the Philips website at www. [. . . ]