User manual PHILIPS FC9306/01

[. . . ] νικα 40 Español 53 Suomi 65 Français 77 Italiano 89 Nederlands 101 Norsk 113 Português 125 Svenska 137 Türkçe 149 2 3 7 9 1 1 2 3 8 10 11 4 5 6 12 16 13 14 15 17 18 19 20 21 25 26 27 22 23 24 28 29 4 English Table of contents Introduction 4 General description 4 Important 5 Before first use 6 Preparing for use 6 Using the appliance 8 Storage 9 Maintenance 10 Ordering accessories 13 Environment 14 Guarantee and service 14 Troubleshooting 14 Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. This vacuum cleaner’s extremely efficient motor produces less noise than other types and yields a high performance at a low power consumption. Danger -- Never suck up water or any other liquid. [. . . ] 3 To switch off the appliance, press the on/off button on top of the appliance. 9 Adjusting suction power 1 During vacuum cleaning, you can adjust the suction power with the selection wheel on top of the appliance. -- Use maximum suction power to vacuum very dirty carpets and hard floors. 3 To ensure stable parking of the telescopic tube, adjust the tube to the shortest length. 4 To continue vacuum cleaning, simply press the on/off button on top of the appliance to switch on the appliance. Storage This vacuum cleaner has not one, but two carrying handles. When it is on its wheels, there is a handle on top which enables you to easily move the cleaner around with very little bending. The second handle on the front side of the appliance enables you to comfortably carry it around in an upright position. 1 Switch off the appliance and remove the mains plug from the wall socket. 2 Press the cord rewind button to rewind the mains cord. 10 English 3 Put the appliance in upright position. To attach the nozzle to the appliance,  insert the ridge on the nozzle into the storage slot. -- To ensure stable parking of the telescopic tube, adjust the tube to the shortest length. Tip:We advise you to wrap the hose around the tube to ensure stable parking and to save even more space when you store the appliance. Maintenance Always unplug the appliance before you clean the appliance, before you replace the dustbag and before you replace the filters. Dustbag Note: In some cases, the dustbag-full indicator can indicate that the dustbag is full, even though it is not. This may occur if the pores of the dustbag are clogged (e. When you have vacuumed ashes, fine sand, lime, cement dust and similar substances) or if something is blocking the nozzle, tube and/or hose. If the pores of the dustbag are clogged, you have to replace the dustbag, even if it is not full yet. If the dustbag is not clogged but not full either, something is blocking the nozzle, tube and/or hose. In this case, do not replace the dustbag but remove the obstruction. -- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i. [. . . ] If you want to minimise the impact on the environment, you can wash the HEPA 13 filter. To wash the HEPA 13 filter, follow the instructions below. 2 Carefully shake the water from the surface of the filter. Let the filter dry completely for at least 2 hours before you put it back into the vacuum cleaner. [. . . ]