User manual PHILIPS FC931

[. . . ] When the nozzle is positioned lengthwise, the suction power is concentrated at the front side of the nozzle. 7) To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the indicated spot and then turn the tube until the nozzle is in the required position. 8) 1 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large hard floor areas. Turn the nozzle until the brush strip pops out of the nozzle housing and the nozzle is positioned breadthwise. [. . . ] 10) 3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean large soft floor areas. Turn the tube 90 degrees anti-clockwise again to position the nozzle breadthwise and to make the brush 6 1 To connect the hose to the appliance, push it into the appliance and turn it clockwise. 1) 2 To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance. To connect the tubes to the handgrip, insert the narrow section into the wider section while turning it. To disconnect the tube from the handgrip, push the lock button and pull the tube out of the handgrip. 11) 4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean small soft floor areas. Turn the tube 90 degrees anti-clockwise again until it is positioned lengthwise with the brush strip still folded in. 1 Replace the dustbag as soon as the dustbagfull indicator changes colour (even when the nozzle is not placed on the floor). 21) Place you fingers at the inlet of the cover and press with your thumb on the ridge on top of the cover. 22) Make sure you hold the dustbag upright when lifting it out of the appliance. 23) When you do this, the dustbag will be automatically sealed. The HEPA filter can be replaced in the same way as the AFS Micro Filter. AFS Micro Filters are available under type number FC8030 (432200492910). HEPA Filters are available under type number FC8031 (432200492920). Activated Carbon Filters are available under type number FC8033 (482248020145). Activated Carbon upgrade kits are available under type number FC8034. Instead of with the Motor Protection Filter, the appliance can be used with an Activated Carbon Filter. this filter neutralises smells produced by the dirt in the dustbag. Replace the Activated Carbon Filter every six months or when you notice that smell absorption becomes less effective. 1 To replace the Activated Carbon Filter , see the Motor Protection Filter section above. Instead of cleaning the filter, you have to insert a new filter. If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, please contact the Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet. [. . . ] To make recycling possible, the plastics used for this appliance have been coded. The AFS Micro Filter located in the back of this appliance will filter a large part of the smallest particles from the exhaust air by means of its electrostatically charged fibres. 28) 4 Insert the new filter into the appliance. 5 Close the filter grille and push the left and right bottom corners until they snap home. [. . . ]