User manual PHILIPS FM25FD11B

[. . . ] Services provided by the Company, such as user support, are also subject to these restrictions. ⷠThe Company cannot accept liability for damage or loss resulting from the use of this unit, or for any claim from a third party. ⷠThe Company cannot accept any liability for: problems with your computer or other hardware arising from the use of this product; the suitability of this product for specific hardware, software, or peripherals; operating conflicts with other installed software; data loss; or other accidental or unavoidable damage. ⷠThe Company cannot accept any liability for financial damages, lost profits, claims from third parties, etc. [. . . ] Note: Do not remove the drive from the computer USB port as long as the download process is in progress. Be sure that the write protection switch (fig. 2 Remove the protective cap from the USB connector and turn it backwards (fig. > The New Hardware wizard starts and the drive's LED lights up. The light intensity of the LED will gradually increase and then diminish again. 7 When the dialog box appears, specify the folder where the installation program is stored. 11 After confirming that the drive is in standby mode you can remove the drive from the computer's USB port. Note: Do not remove the drive from the computer USB port as long as the download process is in progress. Be sure that the write protection switch (fig. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Connecting the drive to your computer Note: If the USB port of your computer is not easily accessible, you can use the USB extension cable supplied (not all models) or an optional USB hub to connect the drive to your computer. 1 Remove the protective cap from the USB connector and turn it backwards (fig. The light intensity of the LED will gradually increase and then diminish again. *This number is for the FCC related matters only. CAUTION: You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] windows® ME and Windows® 2000 1 Double-click the Unplug or eject hardware icon in the task bar in the lower right part of the screen. 2 In the window that appears, select the name of the device that is to be removed, then click the STOP button. 3 When the Stop a harware device screen appears, make sure the correct information is displayed, then click the OK button. 4 When a message appears, indicating that the device can be safely removed, remove the drive from the computer's USB port. [. . . ]