User manual PHILIPS FR755

[. . . ] This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] Positioning the subwoofer A subwoofer can be used to enhance the bass performance of your system dramatically. The subwoofer can be positioned anywhere in the room, because it is not possible to locate the source of deep tones. Nevertheless, you should not place the subwoofer in the middle of a room, since the bass could be severely weakened. Do not place any object on the subwoofer. Note: If you are not completely satisfied with the volume settings, we recommend making minor adjustments to them during surround sound playback. If the receiver is used at very high power, it can produce distortions which may seriously damage your speakers. If distortions occur, reduce the volume and the tone controls to a level where the sound is acceptable again. To avoid overheating of the set a safety circuit has been built in. Therefore your set may disconnect under extreme conditions. If this happens, switch the set off and let it cool down before reusing it. The receiver switches to STEREO and surround sound will be reduced to a stereo signal which is reproducible by standard headphones. disconnecting the headphones switches on the speakers again. If you wish to enjoy surround sound again, switch the receiver back to surround sound. Signs showing you various settings and information about the status of the receiver. The display of the receiver is divided into 3 sections, which are to be used for the following: Menu indication These signs show you if the menu is on or off and indicate in which direction you may move. You may move backwards to the previous menu topic using 1 PREV. You may move up in an option list using X MENU NAVIGATOR ("up" key on the remote control). You may move down in an option list using X MENU NAVIGATOR ("down" key on the remote control). You may move forward to the next menu topic using NEXT 2 ("right" key on the remote control). One of the preset sound settings of the receiver is being used. An RDS station with EON is being received. This area is used for feedback of the receiver, tuner frequencies, menu options, values and scrolling text messages. [. . . ] Three times to display TA and NEWS, this switches on both announcement functions. 3 Select and play any other source as usual. Y While news or traffic information is being broadcast the receiver will switch to tuner and NEWS or TA will flash. 4 Press NEWS/TA until the display indication disappears to switch off the function(s). [. . . ]