User manual PHILIPS FR966

[. . . ] This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] The display of the receiver is divided into 4 sections, which are to be used for the following: Speaker diagram Signs showing you various settings and information about the status of the receiver. An RDS station with EON is being received. Analogue input is being used for the playing source. Coaxial digital input COAX 1 is being used for the playing source. Coaxial digital input COAX 2 is being used for the playing source. Incoming multi channel signals are being reduced to fewer output signals (depending on the number of speakers). Optical digital input OPTICAL IN is being used for the playing source (FR 965 only). Optical digital input OPTICAL 1 IN is being used for the playing source (FR 975 only). FRONT SIZE Left and right front speakers: small/large CENTER SIZE Center speaker: small/large REAR SIZE Rear speakers: small/large * SPK DISTANCE Distance between the usual listening position and the speakers. * SELECT INPUT Assigns the audio input connectors to the different source selections chosen with SOURCE SELECTOR (see "SOURCE SELECTION" for details). If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see "CONNECTIONS"), you may use the TV to set up the system. Consult the instruction booklet of your TV on how to use the TV menu. Press CINEMA LINK to switch the connection between the receiver and the TV either on or off. If CINEMA LINK is switched on and the TV menu is active, TV MENU is displayed and the menu and sound functions on the receiver are locked. When selecting a source by turning SOURCE SELECTOR, the audio and video inputs with the corresponding name are activated. the incoming signal is reproduced by all audio and ­ if the source includes a video signal ­ video outputs of the receiver. It is possible to reassign a source selection to other than these standard inputs. The tuner part of the receiver is used, all inputs are switched off. Using one source selection for two or more appliances You may assign more than one source to a source selection. This can be useful when products are connected one after the other in a chain. example: A VCR is connected to the TV but only the TV is connected to the receiver. Both SOURCE SELECTOR settings, TV as well as VCR, have to use the TV input connectors. [. . . ] 4 Press NEWS/TA until the display indication disappears to switch off the function(s). Or Press NEWS/TA during an announcement to switch off the function(s). Note: Be sure to switch the news and traffic announcement off during recording, otherwise these announcements also will be recorded. Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. [. . . ]