User manual PHILIPS FR995

[. . . ] This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] Analogue input is being used for the playing source. Coaxial digital input COAX 1 is being used for the playing source. Coaxial digital input COAX 2 is being used for the playing source. Incoming multi channel signals are being reduced to fewer output signals (depending on the number of speakers). Optical digital input OPTICAL IN is being used for the playing source (FR 985, FR 986 only). Optical digital input OPTICAL 1 IN is being used for the playing source (FR 995, FR 996 only). Optical digital input OPTICAL 2 IN is being used for the playing source (FR 995, FR 996 only). * SELECT INPUT Assigns the audio input connectors to the different source selections chosen with SOURCE SELECT (see "SOURCE SELECTION" for details). If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see "CONNECTIONS"), you may use the TV to set up the system. Consult the instruction booklet of your TV on how to use the TV menu. Press CINEMA LINK to switch the connection between the receiver and the TV either on or off. If CINEMA LINK is switched on and the TV menu is active, TV MENU is displayed and the menu and sound functions on the receiver are locked. When selecting a source by turning SOURCE SELECT, the audio and video inputs with the corresponding name are activated. the incoming signal is reproduced by all audio and ­ if the source includes a video signal ­ video outputs of the receiver. It is possible to reassign a source selection to other than these standard inputs. The tuner part of the receiver is used, all inputs are switched off. Using one source selection for two or more appliances You may assign more than one source to a source selection. This can be useful when products are connected one after the other in a chain. example: A VCR is connected to the TV but only the TV is connected to the receiver. Both SOURCE SELECT settings, TV as well as VCR, have to use the TV input connectors. 3 Turn X MENU NAVIGATOR to select the input connectors which should be used (e. The 6 CHANNEL / DVD INPUT connectors can be assigned to any of the available sources (excluding TUNER and PHONO). [. . . ] Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock. If a fault occurs, first check the points listed, before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service centre. [. . . ]