User manual PHILIPS FW-C115

[. . . ] Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] ­ Do not load more than one disc into each tray. This system can playback all digital audio CD, finalised digital audio CD-Recordable (CDR) discs and finalised digital audio CD-Rewritable (CDRW)discs. The selected disc tray, total number of tracks and the playing time will appear on the display. notes: ­ Load the discs with the label side facing up. ­ To ensure good system performance, wait until the disc tray completely reads the disc(s) before proceeding. Load up to two discs on the individual disc trays. To load the third disc, press DISC CHANGE. The disc tray will rotate until the empty tray is ready for loading. Å All the available discs will play once, then stop. During playback, the selected disc tray number flashes. The track number and elapsed playing time of the current track are displayed. To play one disc only q In CD mode, press DISC 1/2/3 (or CD DIRECT 1/2/3 on the remote control). The selected disc will play once, then stop. The disc tray will close to retrieve the inner disc, then reopen with the inner disc accessible. You can select and change the various play modes before or during playback. To search for a particular passage during playback q Press and hold à or á and release it when the desired passage is located. during searching , the volume will be reduced. To select a desired track q Press í or ë repeatedly until the desired track is displayed. q If playback is stopped , pressÉ (É) to start Å playback. Note: ­ In Shuffle mode, pressingí will cause the player to skip only to the beginning of the current track. To skip to the beginning of the current track during playback q Press í once. Notes: ­ During programme play or shuffling mode, it is not possible to repeat playback the current disc (Repeat Disc mode). [. . . ] Q The tape is secured at both ends with leader tape. At the beginning and end of the tape, nothing will be recorded for six to seven seconds. Q To prevent accidental recording, break out the tab on the left shoulder of the tape side you want to protect. Q You can programme the tracks in the order you want them to be recorded (refer to "CD Operation - Programming the disc tracks"). [. . . ]