User manual PHILIPS FW-C330-21M

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). ¶ As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: ­ Connect the blue wire to the terminal marked N or coloured black. Connect the brown wire to the terminal marked L or coloured red. [. . . ] Note: ­ Some discs or tapes might be recorded in high modulation, which causes a distortion at high volume. If this occurs, switch off DBB or reduce the volume. automatic DSC-DBB selection The best DBB setting is generated automatically for each DSC selection. You can manually select the DBB setting that best suits your listening environment. Therefore, do not use any accessories such as disc stabiliser rings or disc treatment sheets, etc. , as offered on the market, because they may jam the changer mechanism. ­ Do not load more than one disc into each tray. Load up to two discs on the individual disc trays. To load the third disc, press DISC CHANGE. The disc tray will rotate until the empty tray is ready for loading. This system can playback all digital audio CD, finalised digital audio CD-Recordable (CDR) discs and finalised digital audio CD-Rewritable (CDRW)discs. ­ If you press any of the CD DIRECT 1/2/3 buttons on the remote control, the system will play the selected disc or track, and the stored programme will be ignored temporarily. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. Press and hold à or á until the frequency indication starts to change, then release. The display will show "SEARCH" until a radio station with sufficient signal strength is found. Repeat step 3 if necessary until you find the desired radio station. To begin automatic preset from a desired preset number G Press í or ë to select the desired preset number. If a radio station has been stored in one of the presets, it will not be stored again under another preset number. G To tune to a weak station, press à or á briefly and repeatedly until optimal reception found. The system will automatically store the radio stations with sufficient signal strength, starting from all RDS stations and followed by FM, MW and LW bands respectively. Weak RDS stations may be stored in later presets. When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station (or the first available RDS station) will be played. [. . . ] G It is not possible to listen to another source, except tape dubbing. G It is not possible to activate the timer function during recording or tape dubbing. G You can programme the tracks in the order you want them to be recorded (refer to "CD Operation - Programming the disc tracks"). Before the system switches to standby mode, a countdown of 10 seconds is displayed. [. . . ]